TSENS IP v2.x supports critical interrupts and v2.3+ adds watchdog support in case the FSM is stuck. Enable support in the driver. This series was generated on top of linux-next from 20200130 to integrate some patches that that are queued currently. Changes from v3: - Remove the DTS changes that are already queued - Fix review comments by Bjorn - Fixup patch description to clarify that we don't use TSENS critical interrupts in Linux, but need it for the watchdog support that uses the same HW irq line. - Separate kernel-doc fixes into a separate patch. Changes from v2: - Handle old DTBs w/o critical irq in the same way as fix sent for 5.5 Changes from v1: - Make tsens_features non-const to allow run time detection of features - Pass tsens_sensor around as a const - Fix a bug to release dev pointer in success path - Address review comments from Bjorn and Stephen (thanks for the review) - Add msm8998 and msm8996 DTSI changes for critical interrupts Amit Kucheria (7): drivers: thermal: tsens: Pass around struct tsens_sensor as a constant drivers: thermal: tsens: use simpler variables drivers: thermal: tsens: Release device in success path drivers: thermal: tsens: Add critical interrupt support drivers: thermal: tsens: Add watchdog support drivers: thermal: tsens: kernel-doc fixup drivers: thermal: tsens: Remove unnecessary irq flag drivers/thermal/qcom/tsens-8960.c | 2 +- drivers/thermal/qcom/tsens-common.c | 191 ++++++++++++++++++++++++---- drivers/thermal/qcom/tsens-v2.c | 18 ++- drivers/thermal/qcom/tsens.c | 26 +++- drivers/thermal/qcom/tsens.h | 94 +++++++++++++- 5 files changed, 300 insertions(+), 31 deletions(-) -- 2.20.1
