Adding dsi controller and phy entries for idp dt.
Signed-off-by: Harigovindan P <harigovi@xxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sc7180-idp.dts | 56 +++++++++++++++++++++++++++++++++
1 file changed, 56 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index 388f50a..9f42367 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -7,6 +7,7 @@
/dts-v1/;
+#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/regulator/qcom,rpmh-regulator.h>
#include "sc7180.dtsi"
#include "pm6150.dtsi"
@@ -232,6 +233,50 @@
};
};
+&dsi_controller {
+ status = "okay";
+
+ vdda-supply = <&vreg_l3c_1p2>;
+
+ panel@0 {
+ compatible = "visionox,rm69299-1080p-display";
+ reg = <0>;
+
+ vdda-supply = <&vreg_l8c_1p8>;
+ vdd3p3-supply = <&vreg_l18a_2p8>;
+
+ pinctrl-names = "default", "suspend";
+ pinctrl-0 = <&disp_pins_default>;
+ pinctrl-1 = <&disp_pins_default>;
+
+ reset-gpios = <&pm6150l_gpio 3 GPIO_ACTIVE_HIGH>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ reg = <0>;
+ panel0_in: endpoint {
+ remote-endpoint = <&dsi0_out>;
+ };
+ };
+ };
+ };
+
+ ports {
+ port@1 {
+ endpoint {
+ remote-endpoint = <&panel0_in>;
+ data-lanes = <0 1 2 3>;
+ };
+ };
+ };
+};
+
+&dsi_phy {
+ status = "okay";
+};
+
&qspi {
status = "okay";
pinctrl-names = "default";
@@ -289,6 +334,17 @@
/* PINCTRL - additions to nodes defined in sc7180.dtsi */
+&pm6150l_gpio {
+ disp_pins_default: disp-pins-default{
+ pins = "gpio3";
+ function = "func1";
+ qcom,drive-strength = <2>;
+ power-source = <0>;
+ bias-disable;
+ output-low;
+ };
+};
+
&qspi_clk {
pinconf {
pins = "gpio63";
--
2.7.4
