Re: [PATCH 0/2] ath10k: Enable QDSS clock on sm8150

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed 15 Jan 01:04 PST 2020, Kalle Valo wrote:

> Kalle Valo <kvalo@xxxxxxxxxxxxxx> writes:
> 
> > Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> writes:
> >
> >> On SM8150 the WiFi firmware depends on the QDSS clock ticking, or the system
> >> will reset due to an NoC error. So this adds an optional clock to the ath10k
> >> binding and makes sure it's enabled while the WiFi firmware needs it.
> >>
> >> Bjorn Andersson (2):
> >>   ath10k: Add optional qdss clk
> >>   arm64: dts: qcom: sm8150: Specify qdss clock for wifi
> >>
> >>  .../devicetree/bindings/net/wireless/qcom,ath10k.txt          | 2 +-
> >>  arch/arm64/boot/dts/qcom/sm8150.dtsi                          | 4 ++--
> >>  drivers/net/wireless/ath/ath10k/snoc.c                        | 2 +-
> >>  3 files changed, 4 insertions(+), 4 deletions(-)
> >
> > Via which tree are these supposed to go? I'll take patch 1 and arm
> > mantainers take patch 2, or what?

That sounds good (you take the ath10k and we'll take the dts).

> 
> No reply, so I'm planning to take patch 1. Please holler if I
> misunderstood.
> 

Sorry.

Regards,
Bjorn



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux