The PCIe PHY initialization requires the attached device to be present,
which is primarily achieved by the PCI controller driver. So move the
logic from init/exit to power_on/power_off.
Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
---
Changes since v3:
- Sent separate from SDM845 QMP/QHP series
Changes since v2:
- None
Changes since v1:
- None
drivers/phy/qualcomm/phy-qcom-qmp.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
index 7db2a94f7a99..e107a7eec235 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
@@ -1967,7 +1967,7 @@ static const struct phy_ops qcom_qmp_phy_gen_ops = {
.owner = THIS_MODULE,
};
-static const struct phy_ops qcom_qmp_ufs_ops = {
+static const struct phy_ops qcom_qmp_pcie_ufs_ops = {
.power_on = qcom_qmp_phy_enable,
.power_off = qcom_qmp_phy_disable,
.set_mode = qcom_qmp_phy_set_mode,
@@ -2067,8 +2067,8 @@ int qcom_qmp_phy_create(struct device *dev, struct device_node *np, int id)
}
}
- if (qmp->cfg->type == PHY_TYPE_UFS)
- ops = &qcom_qmp_ufs_ops;
+ if (qmp->cfg->type == PHY_TYPE_UFS || qmp->cfg->type == PHY_TYPE_PCIE)
+ ops = &qcom_qmp_pcie_ufs_ops;
generic_phy = devm_phy_create(dev, np, ops);
if (IS_ERR(generic_phy)) {
--
2.24.0
