[PATCH v2 1/5] phy: qcom-qmp: Increase PHY ready timeout

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>

It's typical for the QHP PHY to take slightly above 1ms to initialize,
so increase the timeout of the PHY ready check to 10ms - as already done
in the downstream PCIe driver.

Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
Tested-by: Evan Green <evgreen@xxxxxxxxxxxx>
Tested-by: Vinod Koul <vkoul@xxxxxxxxxx>
Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
---
 drivers/phy/qualcomm/phy-qcom-qmp.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
index 091e20303a14..66f91726b8b2 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
@@ -66,7 +66,7 @@
 /* QPHY_V3_PCS_MISC_CLAMP_ENABLE register bits */
 #define CLAMP_EN				BIT(0) /* enables i/o clamp_n */
 
-#define PHY_INIT_COMPLETE_TIMEOUT		1000
+#define PHY_INIT_COMPLETE_TIMEOUT		10000
 #define POWER_DOWN_DELAY_US_MIN			10
 #define POWER_DOWN_DELAY_US_MAX			11
 
-- 
2.23.0




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux