On Tue 10 Dec 10:47 PST 2019, Evan Green wrote:
> On Wed, Nov 6, 2019 at 4:09 PM Bjorn Andersson
> <bjorn.andersson@xxxxxxxxxx> wrote:
> >
> > It's typical for the QHP PHY to take slightly above 1ms to initialize,
> > so increase the timeout of the PHY ready check to 10ms - as already done
> > in the downstream PCIe driver.
> >
> > Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
>
> Tested-by: Evan Green <evgreen@xxxxxxxxxxxx>
>
Thanks.
> Should this have a Fixes tag for 14ced7e3a1ae9 ("phy: qcom-qmp:
> Correct ready status, again")?
For UFS it would be 885bd765963b ("phy: qcom-qmp: Correct READY_STATUS
poll break condition"), but I think that before the two we would exit
the poll immediately, so we would only hit the timeout in the "error"
case - where the PHY did come up in a timely fashion.
So I don't think there is a particular commit to "Fixes:"...
But given that this is no longer only needed for the (new) QHP PCIe
instance it would be reasonable to Cc: stable, to get it into v5.4
Regards,
Bjorn
