On Thu, Oct 31, 2019 at 11:35 AM <kholk11@xxxxxxxxx> wrote: > From: AngeloGioacchino Del Regno <kholk11@xxxxxxxxx> > > This patch series enables support for GPIOs and MPPs found on the > PM8950 and PMI8950 ICs, usually found on boards using the MSM8956, > MSM8976, MSM8952, MSM8953 (and APQ variants) SoC. > > These are important to get the PA_THERM, QUIET_THERM MPPs enabled > on PM8950 for standard thermals (and other board specific ones, > where applicable) and GPIOs usually used to enable the audio mclk > path, the wlan sleep clock and sometimes the eLDO for the WCD codec, > plus other board specific paths, where applicable. > For example, on the MSM8956 Sony Xperia Loire platform, this also > includes a GPIO for the USB switch and one for the simple GPIO > controlled vibrator included in all devices for this series of > boards. > > This has been tested on Sony Xperia Loire phones, including the > Xperia X Compact (Kugo) and Xperia X (Suzu). > > AngeloGioacchino Del Regno (4): > pinctrl: qcom: spmi-gpio: Add PM/PMI8950 compatibility > dt-bindings: pinctrl: qcom-pmic-gpio: Add support for PM/PMI8950 > pinctrl: qcom: spmi-mpp: Add PM/PMI8950 compatible strings > dt-bindings: pinctrl: qcom-pmic-mpp: Add support for PM/PMI8950 These patches seem very simple and straight-forward and noncontroversial so I just applied them. Stakeholders can complain if they think otherwise. Yours, Linus Walleij
