From: AngeloGioacchino Del Regno <kholk11@xxxxxxxxx>
Add the SPMI regulator node in the PM8004 LSID5 (as there is where
it resides basically 99% of the times) and set the nodes to be
disabled by default, as not all boards have both or one of the
lsids specified in this generic pm8004 DT.
While at it, also add nice phandles to the lsids specified in this
DT to allow configuration in specific board dts in a more human
readable fashion.
Signed-off-by: AngeloGioacchino Del Regno <kholk11@xxxxxxxxx>
---
arch/arm64/boot/dts/qcom/pm8004.dtsi | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/pm8004.dtsi b/arch/arm64/boot/dts/qcom/pm8004.dtsi
index 297b57bfa87a..0abd1abe12fc 100644
--- a/arch/arm64/boot/dts/qcom/pm8004.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8004.dtsi
@@ -4,17 +4,23 @@
&spmi_bus {
- pmic@4 {
+ pm8004_lsid4: pmic@4 {
compatible = "qcom,pm8004", "qcom,spmi-pmic";
reg = <0x4 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
+ status = "disabled";
};
- pmic@5 {
+ pm8004_lsid5: pmic@5 {
compatible = "qcom,pm8004", "qcom,spmi-pmic";
reg = <0x5 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
+ status = "disabled";
+
+ pm8004_spmi_regulators: regulators {
+ compatible = "qcom,pm8004-regulators";
+ };
};
};
--
2.21.0
