When booting with Device Tree, the current default boot configuration
table option, the request to boot via 'host mode' comes from the
'dr_mode' property. A property of the same name can be used inside
ACPI tables too. However it is missing from the SDM845's ACPI tables
so we have to supply this information using Platform Device Properties
instead.
This does not change the behaviour of any currently supported devices.
The property is only set on ACPI enabled platforms, thus for H/W
booting DT, unless a 'dr_mode' property is present, the default is
still OTG (On-The-Go) as per [0]. Any new ACPI devices added will
also be able to over-ride this implementation by providing a 'dr_mode'
property in their ACPI tables. In cases where 'dr_mode' is omitted
from the tables AND 'host mode' should not be the default (very
unlikely), then we will have to add some way of choosing between them
at run time - most likely by ACPI HID.
[0] Documentation/devicetree/bindings/usb/generic.txt
Signed-off-by: Lee Jones <lee.jones@xxxxxxxxxx>
---
drivers/usb/dwc3/dwc3-qcom.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/usb/dwc3/dwc3-qcom.c b/drivers/usb/dwc3/dwc3-qcom.c
index 1e1f12b7991d..55ba04254e38 100644
--- a/drivers/usb/dwc3/dwc3-qcom.c
+++ b/drivers/usb/dwc3/dwc3-qcom.c
@@ -444,6 +444,11 @@ static int dwc3_qcom_clk_init(struct dwc3_qcom *qcom, int count)
return 0;
}
+static const struct property_entry dwc3_qcom_acpi_properties[] = {
+ PROPERTY_ENTRY_STRING("dr_mode", "host"),
+ {}
+};
+
static int dwc3_qcom_acpi_register_core(struct platform_device *pdev)
{
struct dwc3_qcom *qcom = platform_get_drvdata(pdev);
@@ -488,6 +493,13 @@ static int dwc3_qcom_acpi_register_core(struct platform_device *pdev)
goto out;
}
+ ret = platform_device_add_properties(qcom->dwc3,
+ dwc3_qcom_acpi_properties);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "failed to add properties\n");
+ goto out;
+ }
+
ret = platform_device_add(qcom->dwc3);
if (ret)
dev_err(&pdev->dev, "failed to add device\n");
--
2.17.1
