The gpio interrupt status bit is getting set after the
irq is disabled and causing an immediate interrupt after
enablling the irq, so clear status bit on irq_unmask.
Signed-off-by: Tengfei Fan <tengfeif@xxxxxxxxxxxxxx>
---
drivers/pinctrl/qcom/pinctrl-msm.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/pinctrl/qcom/pinctrl-msm.c b/drivers/pinctrl/qcom/pinctrl-msm.c
index ee81198..7283c50 100644
--- a/drivers/pinctrl/qcom/pinctrl-msm.c
+++ b/drivers/pinctrl/qcom/pinctrl-msm.c
@@ -740,6 +740,7 @@ static void msm_gpio_irq_mask(struct irq_data *d)
static void msm_gpio_irq_unmask(struct irq_data *d)
{
struct gpio_chip *gc = irq_data_get_irq_chip_data(d);
+ uint32_t irqtype = irqd_get_trigger_type(d);
struct msm_pinctrl *pctrl = gpiochip_get_data(gc);
const struct msm_pingroup *g;
unsigned long flags;
@@ -749,6 +750,12 @@ static void msm_gpio_irq_unmask(struct irq_data *d)
raw_spin_lock_irqsave(&pctrl->lock, flags);
+ if (irqtype & (IRQF_TRIGGER_HIGH | IRQF_TRIGGER_LOW)) {
+ val = readl_relaxed(pctrl->regs + g->intr_status_reg);
+ val &= ~BIT(g->intr_status_bit);
+ writel_relaxed(val, pctrl->regs + g->intr_status_reg);
+ }
+
val = msm_readl_intr_cfg(pctrl, g);
val |= BIT(g->intr_raw_status_bit);
val |= BIT(g->intr_enable_bit);
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
