Hi Andrew,
On 18-02-19, 14:33, Andrew Lunn wrote:
> On Mon, Feb 18, 2019 at 06:33:51PM +0530, Vinod Koul wrote:
> > RGMII_ID specifies that we should have internal delay, so resurrect the
> > delay addition routine but under the RGMII_ID mode.
> >
> > Fixes: 40269aa9f40a ("net: dsa: qca8k: disable delay for RGMII mode")
> > Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> > ---
> > drivers/net/dsa/qca8k.c | 12 ++++++++++++
> > 1 file changed, 12 insertions(+)
> >
> > diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
> > index a4b6cda38016..aa1f7f1b20d3 100644
> > --- a/drivers/net/dsa/qca8k.c
> > +++ b/drivers/net/dsa/qca8k.c
> > @@ -443,6 +443,18 @@ qca8k_set_pad_ctrl(struct qca8k_priv *priv, int port, int mode)
> > val = QCA8K_PORT_PAD_RGMII_EN;
> > qca8k_write(priv, reg, val);
> > break;
> > + case PHY_INTERFACE_MODE_RGMII_ID:
> > + /* RGMII_ID needs internal delay. This is enabled through
> > + * PORT5_PAD_CTRL for all ports, rather than individual port
> > + * registers
> > + */
> > + qca8k_write(priv, reg,
> > + QCA8K_PORT_PAD_RGMII_EN |
> > + QCA8K_PORT_PAD_RGMII_TX_DELAY(3) |
> > + QCA8K_PORT_PAD_RGMII_RX_DELAY(3));
> > + qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL,
> > + QCA8K_PORT_PAD_RGMII_RX_DELAY_EN);
> > + break;
>
> Hi Vinod
>
> So i'm still confused if this is global, or per-port. The first
> register written looks to be per-port, although only for ports 0 and
> 6. The second write seems to be global.
This is still a global write which enables the delay in all the ports
(as was the case previously)
> Is there a danger that port 0 has PHY_INTERFACE_MODE_RGMII_ID and port
> 6 has PHY_INTERFACE_MODE_RGMII, and we end up with delays disabled?
> Maybe we should try to detect this, and return an error?
If that was the case, I would presume people would have reported an
issue that it doesn't work for them..?
> > case PHY_INTERFACE_MODE_SGMII:
> > qca8k_write(priv, reg, QCA8K_PORT_PAD_SGMII_EN);
> > break;
>
> I think it would be good to add the other two PHY_INTERFACE_MODE_RGMII
> modes to the default clause so we get an error reported that they are
> not implemented.
That is still the case:
default:
pr_err("xMII mode %d not supported\n", mode);
return -EINVAL;
--
~Vinod
