Add interrupt controller properties now that ssbi-gpio is a proper hierarchical IRQ chip. The interrupts property is no longer needed so remove it. This change was not tested on any hardware but the same change was tested on qcom-pm8941.dtsi with spmi-gpio using a LG Nexus 5 (hammerhead) phone with no issues. Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx> --- arch/arm/boot/dts/qcom-msm8660.dtsi | 47 ++--------------------------- 1 file changed, 2 insertions(+), 45 deletions(-) diff --git a/arch/arm/boot/dts/qcom-msm8660.dtsi b/arch/arm/boot/dts/qcom-msm8660.dtsi index e5da87036dbb..0cf6bb0f869d 100644 --- a/arch/arm/boot/dts/qcom-msm8660.dtsi +++ b/arch/arm/boot/dts/qcom-msm8660.dtsi @@ -287,51 +287,8 @@ compatible = "qcom,pm8058-gpio", "qcom,ssbi-gpio"; reg = <0x150>; - interrupt-parent = <&pm8058>; - interrupts = <192 IRQ_TYPE_NONE>, - <193 IRQ_TYPE_NONE>, - <194 IRQ_TYPE_NONE>, - <195 IRQ_TYPE_NONE>, - <196 IRQ_TYPE_NONE>, - <197 IRQ_TYPE_NONE>, - <198 IRQ_TYPE_NONE>, - <199 IRQ_TYPE_NONE>, - <200 IRQ_TYPE_NONE>, - <201 IRQ_TYPE_NONE>, - <202 IRQ_TYPE_NONE>, - <203 IRQ_TYPE_NONE>, - <204 IRQ_TYPE_NONE>, - <205 IRQ_TYPE_NONE>, - <206 IRQ_TYPE_NONE>, - <207 IRQ_TYPE_NONE>, - <208 IRQ_TYPE_NONE>, - <209 IRQ_TYPE_NONE>, - <210 IRQ_TYPE_NONE>, - <211 IRQ_TYPE_NONE>, - <212 IRQ_TYPE_NONE>, - <213 IRQ_TYPE_NONE>, - <214 IRQ_TYPE_NONE>, - <215 IRQ_TYPE_NONE>, - <216 IRQ_TYPE_NONE>, - <217 IRQ_TYPE_NONE>, - <218 IRQ_TYPE_NONE>, - <219 IRQ_TYPE_NONE>, - <220 IRQ_TYPE_NONE>, - <221 IRQ_TYPE_NONE>, - <222 IRQ_TYPE_NONE>, - <223 IRQ_TYPE_NONE>, - <224 IRQ_TYPE_NONE>, - <225 IRQ_TYPE_NONE>, - <226 IRQ_TYPE_NONE>, - <227 IRQ_TYPE_NONE>, - <228 IRQ_TYPE_NONE>, - <229 IRQ_TYPE_NONE>, - <230 IRQ_TYPE_NONE>, - <231 IRQ_TYPE_NONE>, - <232 IRQ_TYPE_NONE>, - <233 IRQ_TYPE_NONE>, - <234 IRQ_TYPE_NONE>, - <235 IRQ_TYPE_NONE>; + interrupt-controller; + #interrupt-cells = <2>; gpio-controller; #gpio-cells = <2>; -- 2.17.2
