Hi Alok,
Thanks for the patches!
On 1/22/19 08:33, Alok Chauhan wrote:
> Add documentation for the interconnect and interconnect-names bindings
s/interconnect /interconnects /
> for the GENI QUP as detailed by bindings/interconnect/interconnect.txt.
>
> Signed-off-by: Alok Chauhan <alokc@xxxxxxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
> index dab7ca9..44d7e02 100644
> --- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
> +++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
> @@ -17,6 +17,12 @@ Required properties if child node exists:
> - #address-cells: Must be <1> for Serial Engine Address
> - #size-cells: Must be <1> for Serial Engine Address Size
> - ranges: Must be present
> +- interconnects: phandle to a interconnect provider. Please refer
s/a interconnect/an interconnect/
> + ../interconnect/interconnect.txt for details.
> + Must be 2 paths corresponding to 2 AXI ports.
> +- interconnect-names: Port names to differentiate between the
> + 2 interconnect paths defined with interconnect
> + specifier.
>
> Properties for children:
>
> @@ -67,6 +73,10 @@ Example:
> #size-cells = <1>;
> ranges;
>
> + interconnects = <&qnoc 11 &qnoc 512>,
> + <&qnoc 0 &qnoc 543>;
Please take a snippet from your patch 6/6 and put it here instead of the
hard-coded integers above.
> + interconnect-names = "qup-memory", "qup-config";
> +
> i2c0: i2c@a94000 {
> compatible = "qcom,geni-i2c";
> reg = <0xa94000 0x4000>;
>
When you post a new version, please change the subject of the patch
series to PATCH v2, PATCH v3 etc, in order to be able to distinguish
between different versions.
Thanks,
Georgi
