Add interrupt controller properties now that spmi-gpio is a proper hierarchical IRQ chip. The interrupts property is no longer needed so remove it. This change was not tested on any hardware but the same change was tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with no issues. Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx> Reviewed-by: Stephen Boyd <sboyd@xxxxxxxxxx> Reviewed-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> --- Changes since v5: - None Changes since v4: - None Patch introduced in v4. arch/arm64/boot/dts/qcom/pm8005.dtsi | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/pm8005.dtsi b/arch/arm64/boot/dts/qcom/pm8005.dtsi index 4d5aca3eeb69..c0ddf128136c 100644 --- a/arch/arm64/boot/dts/qcom/pm8005.dtsi +++ b/arch/arm64/boot/dts/qcom/pm8005.dtsi @@ -16,10 +16,8 @@ reg = <0xc000>; gpio-controller; #gpio-cells = <2>; - interrupts = <0 0xc0 0 IRQ_TYPE_NONE>, - <0 0xc1 0 IRQ_TYPE_NONE>, - <0 0xc2 0 IRQ_TYPE_NONE>, - <0 0xc3 0 IRQ_TYPE_NONE>; + interrupt-controller; + #interrupt-cells = <2>; }; }; -- 2.17.2
