On Sun 13 Jan 07:47 PST 2019, Brian Masney wrote: > Add interrupt controller properties now that spmi-gpio is a proper > hierarchical IRQ chip. The interrupts property is no longer needed so > remove it. > > This change was not tested on any hardware but the same change was > tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with > no issues. > Reviewed-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> > Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx> > Reviewed-by: Stephen Boyd <sboyd@xxxxxxxxxx> > --- > Chances since v3: > - None > > arch/arm/boot/dts/qcom-pma8084.dtsi | 24 ++---------------------- > 1 file changed, 2 insertions(+), 22 deletions(-) > > diff --git a/arch/arm/boot/dts/qcom-pma8084.dtsi b/arch/arm/boot/dts/qcom-pma8084.dtsi > index aac7e73b6872..8f5ea7add20f 100644 > --- a/arch/arm/boot/dts/qcom-pma8084.dtsi > +++ b/arch/arm/boot/dts/qcom-pma8084.dtsi > @@ -32,28 +32,8 @@ > reg = <0xc000>; > gpio-controller; > #gpio-cells = <2>; > - interrupts = <0 0xc0 0 IRQ_TYPE_NONE>, > - <0 0xc1 0 IRQ_TYPE_NONE>, > - <0 0xc2 0 IRQ_TYPE_NONE>, > - <0 0xc3 0 IRQ_TYPE_NONE>, > - <0 0xc4 0 IRQ_TYPE_NONE>, > - <0 0xc5 0 IRQ_TYPE_NONE>, > - <0 0xc6 0 IRQ_TYPE_NONE>, > - <0 0xc7 0 IRQ_TYPE_NONE>, > - <0 0xc8 0 IRQ_TYPE_NONE>, > - <0 0xc9 0 IRQ_TYPE_NONE>, > - <0 0xca 0 IRQ_TYPE_NONE>, > - <0 0xcb 0 IRQ_TYPE_NONE>, > - <0 0xcc 0 IRQ_TYPE_NONE>, > - <0 0xcd 0 IRQ_TYPE_NONE>, > - <0 0xce 0 IRQ_TYPE_NONE>, > - <0 0xcf 0 IRQ_TYPE_NONE>, > - <0 0xd0 0 IRQ_TYPE_NONE>, > - <0 0xd1 0 IRQ_TYPE_NONE>, > - <0 0xd2 0 IRQ_TYPE_NONE>, > - <0 0xd3 0 IRQ_TYPE_NONE>, > - <0 0xd4 0 IRQ_TYPE_NONE>, > - <0 0xd5 0 IRQ_TYPE_NONE>; > + interrupt-controller; > + #interrupt-cells = <2>; > }; > > pma8084_mpps: mpps@a000 { > -- > 2.17.2 >