Add interrupt controller properties now that spmi-gpio is a proper hierarchical IRQ chip. The interrupts property is no longer needed so remove it. This change was not tested on any hardware but the same change was tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with no issues. Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx> --- This is a new patch introduced in V4. arch/arm64/boot/dts/qcom/pm8998.dtsi | 28 ++-------------------------- 1 file changed, 2 insertions(+), 26 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/pm8998.dtsi b/arch/arm64/boot/dts/qcom/pm8998.dtsi index f1025a50c227..43cb5ea14089 100644 --- a/arch/arm64/boot/dts/qcom/pm8998.dtsi +++ b/arch/arm64/boot/dts/qcom/pm8998.dtsi @@ -94,32 +94,8 @@ reg = <0xc000>; gpio-controller; #gpio-cells = <2>; - interrupts = <0 0xc0 0 IRQ_TYPE_NONE>, - <0 0xc1 0 IRQ_TYPE_NONE>, - <0 0xc2 0 IRQ_TYPE_NONE>, - <0 0xc3 0 IRQ_TYPE_NONE>, - <0 0xc4 0 IRQ_TYPE_NONE>, - <0 0xc5 0 IRQ_TYPE_NONE>, - <0 0xc6 0 IRQ_TYPE_NONE>, - <0 0xc7 0 IRQ_TYPE_NONE>, - <0 0xc8 0 IRQ_TYPE_NONE>, - <0 0xc9 0 IRQ_TYPE_NONE>, - <0 0xca 0 IRQ_TYPE_NONE>, - <0 0xcb 0 IRQ_TYPE_NONE>, - <0 0xcc 0 IRQ_TYPE_NONE>, - <0 0xcd 0 IRQ_TYPE_NONE>, - <0 0xce 0 IRQ_TYPE_NONE>, - <0 0xcf 0 IRQ_TYPE_NONE>, - <0 0xd0 0 IRQ_TYPE_NONE>, - <0 0xd1 0 IRQ_TYPE_NONE>, - <0 0xd2 0 IRQ_TYPE_NONE>, - <0 0xd3 0 IRQ_TYPE_NONE>, - <0 0xd4 0 IRQ_TYPE_NONE>, - <0 0xd5 0 IRQ_TYPE_NONE>, - <0 0xd6 0 IRQ_TYPE_NONE>, - <0 0xd7 0 IRQ_TYPE_NONE>, - <0 0xd8 0 IRQ_TYPE_NONE>, - <0 0xd9 0 IRQ_TYPE_NONE>; + interrupt-controller; + #interrupt-cells = <2>; }; }; -- 2.17.2
