Re: [PATCH] clk: qcom: Add CLK_SET_RATE_PARENT for 8998 branch clocks

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Quoting Jeffrey Hugo (2018-12-17 18:12:14)
> A branch clock is basically a clock that can be gated for power savings,
> but is also what devices/drivers consume.  Configuring a branch clock's
> rate needs to be done at the source, so for all branch clocks which have
> a defined parent, set CLK_SET_RATE_PARENT so that clk_set_rate() calls on
> branch clocks can do what is expected.  This is important as most drivers
> do not check the resulting clock rate after a successful clk_set_rate()
> call, thus the driver may get out of sync with the actual hardware state
> and weird issues might crop up.  This has been observed with issues
> getting SDHCI to reliably support "fast" cards such as SDR104.
> 
> Fixes: 4807c71cc688 (arm64: dts: Add msm8998 SoC and MTP board support)
> Signed-off-by: Jeffrey Hugo <jhugo@xxxxxxxxxxxxxx>
> ---

Applied to clk-next





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux