This series adds the nodes for the SD host controller on SDM845, and wires it up on the MTP. Though I tested similar changes on another board, I was unable to actually run this on an MTP. If someone felt like trying this out on an MTP I would be grateful. The original downstream nodes had sleep pinctrl states. It's not obvious to me that all this messing with drive-strength saves non-negligible amounts of power, so I didn't add them and figured we could add them later if needed. Evan Green (3): dt-bindings: mmc: sdhci-msm: Clarify register requirements arm64: dts: qcom: sdm845: Add SD nodes arm64: dts: qcom: sdm845: Add SD nodes for sdm845-mtp .../devicetree/bindings/mmc/sdhci-msm.txt | 2 +- arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 53 +++++++++++++++++++ arch/arm64/boot/dts/qcom/sdm845.dtsi | 15 ++++++ 3 files changed, 69 insertions(+), 1 deletion(-) -- 2.18.1
