Re: [PATCH v3 4/4] clk: qcom: Add graphics clock controller driver for SDM845

[Stephen Boyd <sboyd@xxxxxxxxxx>]

Quoting Amit Nischal (2018-08-12 23:33:07)
> +
> +static int gpu_cc_sdm845_probe(struct platform_device *pdev)
> +{
> +       struct regmap *regmap;
> +       unsigned int value, mask;
> +       int ret;
> +
> +       regmap = qcom_cc_map(pdev, &gpu_cc_sdm845_desc);
> +       if (IS_ERR(regmap))
> +               return PTR_ERR(regmap);
> +
> +       clk_fabia_pll_configure(&gpu_cc_pll0, regmap, &gpu_cc_pll0_config);
> +       clk_fabia_pll_configure(&gpu_cc_pll1, regmap, &gpu_cc_pll1_config);
> +
> +       /*
> +        * Configure gpu_cc_cx_gmu_clk with recommended
> +        * wakeup/sleep settings
> +        */
> +       mask = CX_GMU_CBCR_WAKE_MASK << CX_GMU_CBCR_WAKE_SHIFT;
> +       mask |= CX_GMU_CBCR_SLEEP_MASK << CX_GMU_CBCR_SLEEP_SHIFT;
> +       value = 0xf << CX_GMU_CBCR_WAKE_SHIFT | 0xf << CX_GMU_CBCR_SLEEP_SHIFT;
> +       regmap_update_bits(regmap, 0x1098, mask, value);
> +
> +       ret = qcom_cc_really_probe(pdev, &gpu_cc_sdm845_desc, regmap);
> +       if (ret)
> +               return ret;
> +
> +       /* Configure clk_dis_wait for gpu_cx_gdsc */
> +       regmap_update_bits(regmap, 0x106c, CLK_DIS_WAIT_MASK,
> +                                               8 << CLK_DIS_WAIT_SHIFT);

Is there a reason this is done after clks are registered? I'd think we
would want to do it before.

> +
> +       /* Set supported range of frequencies for gfx3d clock */
> +       clk_hw_set_rate_range(&gpu_cc_gx_gfx3d_clk_src.clkr.hw, 180000000,
> +                                                               710000000);
> +
> +       return 0;
> +}