Re: [PATCH V4 3/4] spi: spi-geni-qcom: Add SPI driver support for GENI based QUP

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

On Tue, Sep 18, 2018 at 11:09 AM Dilip Kota <dkota@xxxxxxxxxxxxxx> wrote:
>
> From: Girish Mahadevan <girishm@xxxxxxxxxxxxxx>
>
> This driver supports GENI based SPI Controller in the Qualcomm SOCs. The
> Qualcomm Generic Interface (GENI) is a programmable module supporting a
> wide range of serial interfaces including SPI. This driver supports SPI
> operations using FIFO mode of transfer.
>
> Signed-off-by: Girish Mahadevan <girishm@xxxxxxxxxxxxxx>
> Signed-off-by: Dilip Kota <dkota@xxxxxxxxxxxxxx>
> ---
> Addressing all the reviewer commets given in Patchset1.
> Summerizing the chages below:
>
>         Move prepare_transfer_hardware to probe
>         Fix the unbind failure
>         Add Spinlock
>         Use readl/writel() instead of _relaxed()
>         Remove __func__ in dev_err
>         Declare register variables as u32
>         Don't initialize variables and then overwrite them
>         Remove unused step
>         Remove IRQ entry in geni struct
>         Remove extra paranthesis
>         Reframe probe errors
>         Change the tx_fifo_width naming in handle_rx and handle_tx
>         Declare spi_geni_master as 'mas' in complete driver.
>         Correcting the punctuation in the comments.
>         Adding comments in the code while setting Tx WaterMark Register.
>         get_spi_clk_cfg() fixes
>         Rewrite the geni_spi_handle_tx() and geni_spi_handle_rx()
>
> Regarding the suspend/resume and loopback failures, i am working to update in next patch series
> drivers/spi/Kconfig               |  12 +
>  drivers/spi/Makefile              |   1 +
>  drivers/spi/spi-geni-qcom.c       | 653 ++++++++++++++++++++++++++++++++++++++
>  include/linux/spi/spi-geni-qcom.h |  14 +
>  4 files changed, 680 insertions(+)

I've confirmed that all the feedback I'm aware of from previous
versions of this patch has now been addressed, except as noted above:

* suspend callback still looks a little wonky.
* loopback doesn't actually work

IMO it would be OK to land this patch and address the suspend callback
/ loopback issues in later patches, but obviously that's for Mark to
decide.

NOTE: for this patch to land it must be based on a tree that includes
the patch ("soc: qcom: geni: Make version macros simpler") [1] in
order to compile.  It would also be nice if it was also based upon the
patches ("soc: qcom: geni: Don't ignore clk_round_rate() errors in
geni_se_clk_tbl_get()") [2] and ("soc: qcom: geni:
geni_se_clk_freq_match() should always accept multiples") [3].  Those
aren't needed for things to compile but are technically needed for
correctness.  +Andy Gross has said he'll put that the above 3 patches
in his tree in a way that it would be easy to pull in

Mark: it would be super if you had a chance to take a look at this
patch now and see what you think.

[1] https://lkml.kernel.org/r/20180518224750.232742-1-swboyd@xxxxxxxxxxxx
[2] https://lkml.kernel.org/r/20180906224906.93752-1-dianders@xxxxxxxxxxxx
[3] https://lkml.kernel.org/r/20180906224906.93752-2-dianders@xxxxxxxxxxxx

With all that said, I'm happy adding:

Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
Tested-by: Douglas Anderson <dianders@xxxxxxxxxxxx>


-Doug



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux