On Thu, Aug 16, 2018 at 10:06 PM Stephen Boyd <swboyd@xxxxxxxxxxxx> wrote: > The interrupt controller hardware in this pin controller has two status > enable bits. The first "normal" status enable bit enables or disables > the summary interrupt line being raised when a gpio interrupt triggers > and the "raw" status enable bit allows or prevents the hardware from > latching an interrupt into the status register for a gpio interrupt. > Currently we just toggle the "normal" status enable bit in the mask and > unmask ops so that the summary irq interrupt going to the CPU's > interrupt controller doesn't trigger for the masked gpio interrupt. > > For a level triggered interrupt, the flow would be as follows: the pin > controller sees the interrupt, latches the status into the status > register, raises the summary irq to the CPU, summary irq handler runs > and calls handle_level_irq(), handle_level_irq() masks and acks the gpio > interrupt, the interrupt handler runs, and finally unmask the interrupt. > When the interrupt handler completes, we expect that the interrupt line > level will go back to the deasserted state so the genirq code can unmask > the interrupt without it triggering again. > > If we only mask the interrupt by clearing the "normal" status enable bit > then we'll ack the interrupt but it will continue to show up as pending > in the status register because the raw status bit is enabled, the > hardware hasn't deasserted the line, and thus the asserted state latches > into the status register again. When the hardware deasserts the > interrupt the pin controller still thinks there is a pending unserviced > level interrupt because it latched it earlier. This behavior causes > software to see an extra interrupt for level type interrupts each time > the interrupt is handled. > > Let's fix this by clearing the raw status enable bit for level type > interrupts so that the hardware stops latching the status of the > interrupt after we ack it. We don't do this for edge type interrupts > because it seems that toggling the raw status enable bit for edge type > interrupts causes spurious edge interrupts. > > Cc: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> > Cc: Doug Anderson <dianders@xxxxxxxxxxxx> > Signed-off-by: Stephen Boyd <swboyd@xxxxxxxxxxxx> This patch applied for fixes with Doug and Bjorn's ACKs. I suppose you will respin the two others and obtain buy-in from the same people for these. Yours, Linus Walleij
