On Wed, Aug 01 2018 at 16:38 -0600, Bjorn Andersson wrote:
On Wed 01 Aug 12:45 PDT 2018, Lina Iyer wrote:
Thanks for the feedback, Marc.
On Wed, Aug 01 2018 at 00:31 -0600, Marc Zyngier wrote:
> On Wed, 01 Aug 2018 03:00:18 +0100,
> Lina Iyer <ilina@xxxxxxxxxxxxxx> wrote:
[..]
> Why isn't that the case? And if that's because the HW is broken and
> doesn't buffer edge interrupts, why can't you use the resend mechanism
> instead?
>
The PDC hardware can replay the interrupts accurately. However, it will
replay only the pin and its not the TLMM summary IRQ. The handler here,
needs to notify the driver that the wakeup interrupt happened and needs
to take action. If I could trip the summary IRQ in this handler that
would work too. Can it be done?
Does this means that the intr_status_reg will not hold the information
about the interrupt events that occurred before we powered on the TLMM
again? Or is the problem limited to it not triggering the TLMM IRQ?
It doesn't. The TLMM is in low power state and cannot sense interrupts.
Can the PDC (and MPM) be used in the non-sleep use cases as well?
Yes. We use PDC to modify polarity of falling edge and low level
interrupts to rising edge and high level interrupt so they may be sensed
at the GIC. I am not sure about the MPM. I suspect it is not.
-- Lina
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
