Re: [PATCH v3 1/2] regulator: dt-bindings: add QCOM RPMh regulator bindings

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, May 30, 2018 at 09:41:55AM -0700, Doug Anderson wrote:
> On Wed, May 30, 2018 at 9:36 AM, Mark Brown <broonie@xxxxxxxxxx> wrote:

> > Yeah, and I don't think that's unreasonable for the core to do - just
> > drop the voltage to the constraint minimum after it has turned off the
> > regulator, then recheck and raise if needed before it enables again.

> Would it do this for all regulators, though?  Most regulators are
> hooked up over a slow i2c bus, so that means that every regulator
> disable would now do an extra i2c transfer even though for all
> regulators (other than RPMh) the voltage of a regulator doesn't matter
> when it's been "disabled' (from Linux's point of view).

It'd only affect regulators that can vary in voltage and actually get
disabled which is a pretty small subset.  Most regulators are either
fixed voltage or always on.

> Hrmmm, I suppose maybe it'd be OK though because for most regulators
> we'd use "regcache" and most regulators that we enabled/disable a lot
> are not expected to change voltage in Linux (so the regcache write
> would hopefully be a noop), so maybe it wouldn't be _that_
> inefficient...

Even if the regulator lacks a cache we'd at least skip out on the write
when we're not changing voltage as we'd do a read/modify/update cycle
and stop at the modify.

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux