Hi Abhishek, On Fri, 25 May 2018 17:51:31 +0530, Abhishek Sahu <absahu@xxxxxxxxxxxxxx> wrote: > If nand-ecc-strength specified in DT, then controller will use > this ECC strength otherwise ECC strength will be calculated > according to chip requirement and available OOB size. > > Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx> > --- > * Changes from v2: > NONE > > * Changes from v1: > NEW PATCH > > Documentation/devicetree/bindings/mtd/qcom_nandc.txt | 4 +++- > 1 file changed, 3 insertions(+), 1 deletion(-) > > diff --git a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt > index 73d336be..f246aa0 100644 > --- a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt > +++ b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt > @@ -45,11 +45,13 @@ Required properties: > number (e.g., 0, 1, 2, etc.) > - #address-cells: see partition.txt > - #size-cells: see partition.txt > -- nand-ecc-strength: see nand.txt > - nand-ecc-step-size: must be 512. see nand.txt for more details. I think you can squash the two dt-bindings commits as they are tightly related to each other. > > Optional properties: > - nand-bus-width: see nand.txt > +- nand-ecc-strength: see nand.txt. If not specified, then ECC strength will > + be used according to chip requirement and available > + OOB size. > > Each nandcs device node may optionally contain a 'partitions' sub-node, which > further contains sub-nodes describing the flash partition mapping. See -- Miquel Raynal, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering https://bootlin.com -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
