Add a common device tree property for regulator nodes to support the specification of allowed operating modes. Signed-off-by: David Collins <collinsd@xxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/regulator/regulator.txt | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt index 2babe15b..c627aa0 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.txt +++ b/Documentation/devicetree/bindings/regulator/regulator.txt @@ -59,6 +59,11 @@ Optional properties: - regulator-initial-mode: initial operating mode. The set of possible operating modes depends on the capabilities of every hardware so each device binding documentation explains which values the regulator supports. +- regulator-allowed-modes: list of operating modes that software is allowed to + configure for the regulator at run-time. Elements may be specified in any + order. The set of possible operating modes depends on the capabilities of + every hardware so each device binding document explains which values the + regulator supports. - regulator-system-load: Load in uA present on regulator that is not captured by any consumer request. - regulator-pull-down: Enable pull down resistor when the regulator is disabled. -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
