Quoting Amit Nischal (2018-05-07 03:50:18)
> For some root clock generators, there could be child branches which are
> controlled by an entity other than application processor subsystem. For
> such RCGs, as per application processor subsystem clock driver, all of
> its downstream clocks are disabled and RCG is in disabled state but in
> reality downstream clocks can be left enabled before.
>
> So in this scenario, when RCG is disabled as per clock driver's point of
> view and when rate scaling request comes before downstream clock enable
> request, then RCG fails to update its configuration because in reality
> RCG is on and it expects its new source to already be in enable state but
> in reality new source is off. In order to avoid having the RCG to go into
> an invalid state, add support to update the CFG, M, N and D registers
> during set_rate() without configuration update and defer the actual RCG
> configuration update to be done during clk_enable() as at this point of
> time, both its new parent and safe source will be already enabled and RCG
> can safely switch to new parent.
>
> During clk_disable() request, configure it to safe source as both its
> parents, safe source and current parent will be enabled and RCG can
> safely execute a switch.
>
> Signed-off-by: Taniya Das <tdas@xxxxxxxxxxxxxx>
> Signed-off-by: Amit Nischal <anischal@xxxxxxxxxxxxxx>
> ---
Applied to clk-next. I squashed some style fixups and logic
simplifications in too.
diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
index 6827ab32c82c..e63911cbfef9 100644
--- a/drivers/clk/qcom/clk-rcg2.c
+++ b/drivers/clk/qcom/clk-rcg2.c
@@ -797,7 +797,6 @@ static int clk_rcg2_set_force_enable(struct clk_hw *hw)
const char *name = clk_hw_get_name(hw);
int ret, count;
- /* Force enable bit */
ret = regmap_update_bits(rcg->clkr.regmap, rcg->cmd_rcgr + CMD_REG,
CMD_ROOT_EN, CMD_ROOT_EN);
if (ret)
@@ -808,12 +807,10 @@ static int clk_rcg2_set_force_enable(struct clk_hw *hw)
if (clk_rcg2_is_enabled(hw))
return 0;
- /* Delay for 1usec and retry polling the status bit */
udelay(1);
}
- if (!count)
- pr_err("%s: RCG did not turn on\n", name);
+ pr_err("%s: RCG did not turn on\n", name);
return -ETIMEDOUT;
}
@@ -821,7 +818,6 @@ static int clk_rcg2_clear_force_enable(struct clk_hw *hw)
{
struct clk_rcg2 *rcg = to_clk_rcg2(hw);
- /* Clear force enable bit */
return regmap_update_bits(rcg->clkr.regmap, rcg->cmd_rcgr + CMD_REG,
CMD_ROOT_EN, 0);
}
@@ -832,9 +828,6 @@ clk_rcg2_shared_force_enable_clear(struct clk_hw *hw, const struct freq_tbl *f)
struct clk_rcg2 *rcg = to_clk_rcg2(hw);
int ret;
- if (!f)
- return -EINVAL;
-
ret = clk_rcg2_set_force_enable(hw);
if (ret)
return ret;
@@ -858,10 +851,9 @@ static int clk_rcg2_shared_set_rate(struct clk_hw *hw, unsigned long rate,
/*
* In case clock is disabled, update the CFG, M, N and D registers
- * and do not hit the update bit of CMD register.
+ * and don't hit the update bit of CMD register.
*/
if (!__clk_is_enabled(hw->clk))
- /* Skip the configuration update */
return __clk_rcg2_configure(rcg, f);
return clk_rcg2_shared_force_enable_clear(hw, f);
@@ -879,8 +871,8 @@ static int clk_rcg2_shared_enable(struct clk_hw *hw)
int ret;
/*
- * Set the update bit only.
- * As required configuration has been already written in set_rate() op.
+ * Set the update bit because required configuration has already
+ * been written in set_rate() op.
*/
ret = clk_rcg2_set_force_enable(hw);
if (ret)
@@ -899,8 +891,8 @@ static void clk_rcg2_shared_disable(struct clk_hw *hw)
u32 cfg;
/*
- * Store current configuration as switching to safe source
- * would clear the SRC and DIV of CFG register.
+ * Store current configuration as switching to safe source would clear
+ * the SRC and DIV of CFG register.
*/
regmap_read(rcg->clkr.regmap, rcg->cmd_rcgr + CFG_REG, &cfg);
@@ -915,7 +907,7 @@ static void clk_rcg2_shared_disable(struct clk_hw *hw)
clk_rcg2_set_force_enable(hw);
regmap_write(rcg->clkr.regmap, rcg->cmd_rcgr + CFG_REG,
- rcg->safe_src_index << CFG_SRC_SEL_SHIFT);
+ rcg->safe_src_index << CFG_SRC_SEL_SHIFT);
update_config(rcg);
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
