Hi Manu,
On Fri, Apr 13, 2018 at 10:21:23PM +0530, Manu Gautam wrote:
> DWC3 controller on Qualcomm SOCs has a Qscratch wrapper.
> Some of its uses are described below resulting in need to
> have a separate glue driver instead of using dwc3-of-simple:
> - It exposes register interface to override vbus-override
> and lane0-pwr-present signals going to hardware. These
> must be updated in peripheral mode for DWC3 if vbus lines
> are not connected to hardware block. Otherwise RX termination
> in SS mode or DP pull-up is not applied by device controller.
> - pwr_events_irq_stat support to check if USB2 PHY is in L2 state
> before glue driver proceeds with suspend.
> - Support for wakeup interrupts lines that are asserted whenever
> there is any wakeup event on USB3 or USB2 bus.
> - Support to replace pip3 clock going to DWC3 with utmi clock
> for hardware configuration where SSPHY is not used with DWC3.
>
> Signed-off-by: Manu Gautam <mgautam@xxxxxxxxxxxxxx>
<snip>
> +static int dwc3_qcom_register_extcon(struct dwc3_qcom *qcom)
> +{
> + struct device *dev = qcom->dev;
> + struct extcon_dev *host_edev;
> + int ret;
> +
> + if (!of_property_read_bool(dev->of_node, "extcon"))
> + return 0;
> +
> + qcom->edev = extcon_get_edev_by_phandle(dev, 0);
Are the extcon phandles bound to the glue node? I don't see the
description in the bindings doc in PATCH 1/3. And if so, would it be
a duplicate of the child node's extcon binding? Then again, the
alternative would be to grab it directly from the child (i.e.
qcom->dwc3->dev.of_node) which I'm not sure is ok to do or not.
Jack
--
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
