On Fri, Apr 7, 2017 at 9:55 PM, Sinan Kaya <okaya@xxxxxxxxxxxxxx> wrote: > Now that we added a hook to be called from device_add, save the > default values from the HW registers early in the boot for further > reuse during hot device add/remove operations. > > If the link is down during boot, assume that we want to enable L0s > and L1 following hotplug insertion as well as L1SS if supported. IIUC, so far POLICY_DEFAULT meant that we'd just use & follow what BIOS has done, and play it safe (never try to be more opportunistic). With this change however, we'd be slightly overstepping and giving ourselves benefit of doubt if the BIOS could not enable ASPM states because the link was not up. This may be good, but I think we should call it out, and add some more elaborate comment on the POLICY_DEFAULT description (what to, and what not to expect in different situations). It is important because existing systems today, that used to boot without cards and later hotplugged them, didn't have ASPM states enabled. They will now suddenly start seeing all ASPM states enabled including L1 substates for the first time (if supported). My system is not hotplug capable (I have the EP soldered on board, so couldn't do much testing, except for sanity. Please feel free to use my Reviewed-by. > > Fixes: https://bugzilla.kernel.org/show_bug.cgi?id=194895 > Signed-off-by: Sinan Kaya <okaya@xxxxxxxxxxxxxx> > --- > drivers/pci/pcie/aspm.c | 34 ++++++++++++++++++++++++++++++---- > 1 file changed, 30 insertions(+), 4 deletions(-) > > diff --git a/drivers/pci/pcie/aspm.c b/drivers/pci/pcie/aspm.c > index e33f84b..c7da087 100644 > --- a/drivers/pci/pcie/aspm.c > +++ b/drivers/pci/pcie/aspm.c > @@ -505,8 +505,10 @@ static void pcie_aspm_cap_init(struct pcie_link_state *link, int blacklist) > */ > if (dwreg.support & upreg.support & PCIE_LINK_STATE_L0S) > link->aspm_support |= ASPM_STATE_L0S; > - if (dwreg.enabled & PCIE_LINK_STATE_L0S) > + if (dwreg.enabled & PCIE_LINK_STATE_L0S) { > link->aspm_enabled |= ASPM_STATE_L0S_UP; > + link->aspm_default |= ASPM_STATE_L0S_UP; > + } > if (upreg.enabled & PCIE_LINK_STATE_L0S) > link->aspm_enabled |= ASPM_STATE_L0S_DW; > link->latency_up.l0s = calc_l0s_latency(upreg.latency_encoding_l0s); > @@ -542,9 +544,6 @@ static void pcie_aspm_cap_init(struct pcie_link_state *link, int blacklist) > if (link->aspm_support & ASPM_STATE_L1SS) > aspm_calc_l1ss_info(link, &upreg, &dwreg); > > - /* Save default state */ > - link->aspm_default = link->aspm_enabled; > - > /* Setup initial capable state. Will be updated later */ > link->aspm_capable = link->aspm_support; > /* > @@ -835,11 +834,38 @@ static int pci_aspm_init_downstream(struct pci_dev *pdev) > static int pci_aspm_init_upstream(struct pci_dev *pdev) > { > struct pcie_link_state *link; > + struct aspm_register_info upreg; > + u16 lnk_status; > + bool ret; > > link = alloc_pcie_link_state(pdev); > if (!link) > return -ENOMEM; > > + pcie_capability_read_word(pdev, PCI_EXP_LNKSTA, &lnk_status); > + ret = !!(lnk_status & PCI_EXP_LNKSTA_DLLLA); > + > + if (ret) { > + pcie_get_aspm_reg(pdev, &upreg); > + if (upreg.enabled & PCIE_LINK_STATE_L0S) > + link->aspm_default |= ASPM_STATE_L0S_DW; > + if (upreg.enabled & PCIE_LINK_STATE_L1) > + link->aspm_default |= ASPM_STATE_L1; > + if (upreg.l1ss_ctl1 & PCI_L1SS_CTL1_ASPM_L1_1) > + link->aspm_default |= ASPM_STATE_L1_1; > + if (upreg.l1ss_ctl1 & PCI_L1SS_CTL1_ASPM_L1_2) > + link->aspm_default |= ASPM_STATE_L1_2; > + if (upreg.l1ss_ctl1 & PCI_L1SS_CTL1_PCIPM_L1_1) > + link->aspm_default |= ASPM_STATE_L1_1_PCIPM; > + if (upreg.l1ss_ctl1 & PCI_L1SS_CTL1_PCIPM_L1_2) > + link->aspm_default |= ASPM_STATE_L1_2_PCIPM; > + } else { > + if (!pci_find_ext_capability(pdev, PCI_EXT_CAP_ID_L1SS)) > + link->aspm_default = ASPM_STATE_L0S | ASPM_STATE_L1; > + else > + link->aspm_default = ASPM_STATE_ALL; > + } Optional: May be consider moving this code (more aptly) to pcie_aspm_cap_init() by adding a check for link-up before we start reading downstream registers there? I guess you'll need to move the call to pcie_aspm_cap_init() a little further up in pcie_aspm_init_link_state(). > + > return 0; > } > > -- > 1.9.1 > -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
