This provides enhanced_strobe mode feature support in sdhci-msm driver. Signed-off-by: Ritesh Harjani <riteshh@xxxxxxxxxxxxxx> --- drivers/mmc/host/sdhci-msm.c | 34 +++++++++++++++++++++++++--------- 1 file changed, 25 insertions(+), 9 deletions(-) diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c index fa9bce3..f958697 100644 --- a/drivers/mmc/host/sdhci-msm.c +++ b/drivers/mmc/host/sdhci-msm.c @@ -103,6 +103,7 @@ #define CORE_DDR_200_CFG 0x184 #define CORE_CDC_T4_DLY_SEL BIT(0) +#define CORE_CMDIN_RCLK_EN BIT(1) #define CORE_START_CDC_TRAFFIC BIT(6) #define CORE_VENDOR_SPEC3 0x1b0 #define CORE_PWRSAVE_DLL BIT(3) @@ -547,6 +548,7 @@ static void msm_hc_select_hs400(struct sdhci_host *host) { struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host); + struct mmc_ios ios = host->mmc->ios; u32 config, dll_lock; int rc; @@ -560,7 +562,8 @@ static void msm_hc_select_hs400(struct sdhci_host *host) * Select HS400 mode using the HC_SELECT_IN from VENDOR SPEC * register */ - if (msm_host->tuning_done && !msm_host->calibration_done) { + if ((msm_host->tuning_done || ios.enhanced_strobe) && + !msm_host->calibration_done) { config = readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC); config |= CORE_HC_SELECT_IN_HS400; config |= CORE_HC_SELECT_IN_EN; @@ -734,6 +737,7 @@ static int sdhci_msm_cdclp533_calibration(struct sdhci_host *host) static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host) { + struct mmc_host *mmc = host->mmc; u32 dll_status, config; int ret; @@ -748,6 +752,12 @@ static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host) */ writel_relaxed(DDR_CONFIG_POR_VAL, host->ioaddr + CORE_DDR_CONFIG); + if (mmc->ios.enhanced_strobe) { + config = readl_relaxed(host->ioaddr + CORE_DDR_200_CFG); + config |= CORE_CMDIN_RCLK_EN; + writel_relaxed(config, host->ioaddr + CORE_DDR_200_CFG); + } + config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG_2); config |= CORE_DDR_CAL_EN; writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG_2); @@ -782,6 +792,7 @@ static int sdhci_msm_hs400_dll_calibration(struct sdhci_host *host) { struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host); + struct mmc_host *mmc = host->mmc; int ret; u32 config; @@ -795,14 +806,17 @@ static int sdhci_msm_hs400_dll_calibration(struct sdhci_host *host) if (ret) goto out; - /* Set the selected phase in delay line hw block */ - ret = msm_config_cm_dll_phase(host, msm_host->saved_tuning_phase); - if (ret) - goto out; + if (!mmc->ios.enhanced_strobe) { + /* Set the selected phase in delay line hw block */ + ret = msm_config_cm_dll_phase(host, + msm_host->saved_tuning_phase); + if (ret) + goto out; + config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG); + config |= CORE_CMD_DAT_TRACK_SEL; + writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG); + } - config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG); - config |= CORE_CMD_DAT_TRACK_SEL; - writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG); if (msm_host->use_cdclp533) ret = sdhci_msm_cdclp533_calibration(host); else @@ -899,6 +913,7 @@ static int sdhci_msm_execute_tuning(struct sdhci_host *host, u32 opcode) /* * sdhci_msm_hs400 - Calibrate the DLL for HS400 bus speed mode operation. + * This needs to be done for both tuning and enhanced_strobe mode. * DLL operation is only needed for clock > 100MHz. For clock <= 100MHz * fixed feedback clock is used. */ @@ -909,7 +924,8 @@ static void sdhci_msm_hs400(struct sdhci_host *host, struct mmc_ios *ios) int ret; if (host->clock > CORE_FREQ_100MHZ && - msm_host->tuning_done && !msm_host->calibration_done) { + (msm_host->tuning_done || ios->enhanced_strobe) && + !msm_host->calibration_done) { ret = sdhci_msm_hs400_dll_calibration(host); if (!ret) msm_host->calibration_done = true; -- The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project. -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html