On 9/16/2016 4:06 PM, Sinan Kaya wrote:
> An endpoint is allowed to issue CRS following an FLR request to indicate
> that it is not ready to accept new requests. Changing the polling mechanism
> in FLR wait function to go read the vendor ID instead of the command/status
> register. A CRS indication will only be given if the address to be read is
> vendor ID.
>
> Signed-off-by: Sinan Kaya <okaya@xxxxxxxxxxxxxx>
> ---
> drivers/pci/pci.c | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
> index e913467..1def11e 100644
> --- a/drivers/pci/pci.c
> +++ b/drivers/pci/pci.c
> @@ -3729,7 +3729,8 @@ static void pci_flr_wait(struct pci_dev *dev)
>
> do {
> msleep(100);
> - pci_read_config_dword(dev, PCI_COMMAND, &id);
> + pci_bus_read_dev_vendor_id(dev->bus, dev->devfn, &id,
> + 60 * 1000);
We found out during Mellanox CX3 testing that the card returns the vendor
ID earlier during FLR while other cards are OK with this implementaiton.
I think we need both of the reads to support the CRS for the endpoints
and also the command id register read to make sure endpoint init is complete.
> } while (i++ < 10 && id == ~0);
>
> if (id == ~0)
>
--
Sinan Kaya
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project.
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
