Hi Rob,
On 10/11/2016 6:01 PM, Rob Herring wrote:
On Tue, Oct 11, 2016 at 4:06 AM, Ritesh Harjani <riteshh@xxxxxxxxxxxxxx> wrote:
Hi Rob
On 10/11/2016 12:59 AM, Rob Herring wrote:
On Mon, Oct 10, 2016 at 11:07 AM, Ritesh Harjani <riteshh@xxxxxxxxxxxxxx>
wrote:
Hi Rob,
Thanks for review.
On 10/10/2016 6:27 PM, Rob Herring wrote:
On Wed, Oct 05, 2016 at 08:10:31PM +0530, Ritesh Harjani wrote:
This adds support for sdhc-msm controllers to get supported
clk-rates from DT. sdhci-msm would need it's own set_clock
ops to be implemented. For this, supported clk-rates needs
to be populated in sdhci_msm_pltfm_data.
Signed-off-by: Ritesh Harjani <riteshh@xxxxxxxxxxxxxx>
---
.../devicetree/bindings/mmc/sdhci-msm.txt | 1 +
drivers/mmc/host/sdhci-msm.c | 48
++++++++++++++++++++++
2 files changed, 49 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
index 485483a..6a83b38 100644
--- a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
+++ b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
@@ -17,6 +17,7 @@ Required properties:
"iface" - Main peripheral bus clock (PCLK/HCLK - AHB Bus clock)
(required)
"core" - SDC MMC clock (MCLK) (required)
"bus" - SDCC bus voter clock (optional)
+- clk-rates: Array of supported GCC clock frequencies for sdhc, Units
-
Hz.
Why can't some combination of assigned-clock-rates and querying the
clock provider for rates be used here?
From what I understood, assigned-clock-rates would only work for setting
some default clock rates for certain clocks by calling
of_clk_set_defaults.
Whereas the requirement here is -
That since SDHC msm directly controls the clk(core clock) at source, it's
sdhci-msm driver needs to know the supported clk-rates by the underlying
platform to configure the nearest floor value supported on this platform
(when the request arrives from the core layer to switch the clock).
Why does clk_round_rate not work for you? That will round down to the
nearest frequency supported.
clk_round_rate will round off to nearest supported "ceil" frequency.
But we require nearest rounded off "floor" frequency.
Then fix the clk framework to do what you want. This doesn't need to be in DT.
Sure. Discussed with clk driver. Will make the required changes in qcom
clk driver to fix this.
Will soon publish the new series.
Rob
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
