On Thu, Nov 3, 2016 at 10:15 PM, Michael Scott <michael.scott@xxxxxxxxxx> wrote: > Initial pinctrl driver for QCOM msm8994 platforms. > > In order to continue the initial board support for QCOM msm8994/msm8992 > presented in patches from Jeremy McNicoll <jeremymc@xxxxxxxxxx>, let's put > a proper pinctrl driver in place. > > Currently, the DT for these platforms uses the msm8x74 pinctrl driver to > enable basic UART. Beyond the first few pins the rest are different enough > to justify it's own driver. > > Note: This driver is also used by QCOM's msm8992 platform as it's TLM block > is the same. > > - Initial formatting and style was taken from the msm8x74 pinctrl driver > added by Björn Andersson <bjorn.andersson@xxxxxxxxxx> > - Data was then adjusted per QCOM MSM8994v2 documentation for Top Level > Multiplexing > - Bindings documentation was based on qcom,msm8996-pinctrl.txt by > Joonwoo Park <joonwoop@xxxxxxxxxxxxxx> and then modified for msm8994 > content > > Signed-off-by: Michael Scott <michael.scott@xxxxxxxxxx> > Tested-by: Jeremy McNicoll <jeremymc@xxxxxxxxxx> > Acked-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> > Acked-by: Rob Herring <robh@xxxxxxxxxx> > --- > V5: This v5 version applied. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
