On 20 October 2016 at 09:21, Sinan Kaya <okaya@xxxxxxxxxxxxxx> wrote:
> The SCI penalize function was removed in two steps (first refactor
> and then remove) and these changes are reverted here in one go.
>
> The commit 103544d86976 ("ACPI,PCI,IRQ: reduce resource requirements")
> refactored the original code so that SCI penalty is calculated dynamically
> by the time get_penalty function is called. That change is partially
> reverted here, specifically for the SCI IRQ alone.
>
> The SCI penalize function was finally dropped by commit 9e5ed6d1fb87
> ("ACPI,PCI,IRQ: remove SCI penalize function") that replaced the old SCI
> penalty API with penalty calculation carried out dynamically and based
> on the acpi_gbl_FADT.sci_interrupt value.
>
> However, that new algorithm relies on the accurate setting of IRQ
> types and that doesn't happen early enough on some platforms which
> leads to incorrect penalty assignments for PCI IRQs. In those cases,
> irq_get_trigger_type() returns incorrect values for the IRQs in
> question, because they have not been registered yet by the time the
> penalties are calculated.
>
> To fix this problem, we only need to fix the penalty for the SCI interrupt.
> It seems better to add a single "sci_penalty" variable, set it to
> PIRQ_PENALTY_PCI_USING if it's level/low or PIRQ_PENALTY_ISA_ALWAYS
> otherwise, and add "sci_penalty" in when appropriate. That should fix it
> for *any* SCI IRQ, not just those less than 256, and we don't have to add
> these extra penalty table entries that are all unused (except possibly for
> one entry if we have an SCI in the 16-255 range).
>
> For this reason, revert commit 9e5ed6d1fb87 ("ACPI,PCI,IRQ: remove SCI
> penalize function") completely to restore the correct behavior.
>
> Link: https://lkml.org/lkml/2016/10/4/283
> Signed-off-by: Sinan Kaya <okaya@xxxxxxxxxxxxxx>
> Fixes: commit 103544d86976 ("ACPI,PCI,IRQ: reduce resource requirements")
> Fixes: commit 9e5ed6d1fb87 ("ACPI,PCI,IRQ: remove SCI penalize function")
> ---
> arch/x86/kernel/acpi/boot.c | 1 +
> drivers/acpi/pci_link.c | 30 +++++++++++++++---------------
> include/linux/acpi.h | 1 +
> 3 files changed, 17 insertions(+), 15 deletions(-)
>
> diff --git a/arch/x86/kernel/acpi/boot.c b/arch/x86/kernel/acpi/boot.c
> index 90d84c3..0ffd26e 100644
> --- a/arch/x86/kernel/acpi/boot.c
> +++ b/arch/x86/kernel/acpi/boot.c
> @@ -453,6 +453,7 @@ static void __init acpi_sci_ioapic_setup(u8 bus_irq, u16 polarity, u16 trigger,
> polarity = acpi_sci_flags & ACPI_MADT_POLARITY_MASK;
>
> mp_override_legacy_irq(bus_irq, polarity, trigger, gsi);
> + acpi_penalize_sci_irq(bus_irq, trigger, polarity);
>
> /*
> * stash over-ride to indicate we've been here
> diff --git a/drivers/acpi/pci_link.c b/drivers/acpi/pci_link.c
> index 4f37938..294b190 100644
> --- a/drivers/acpi/pci_link.c
> +++ b/drivers/acpi/pci_link.c
> @@ -87,6 +87,7 @@ struct acpi_pci_link {
>
> static LIST_HEAD(acpi_link_list);
> static DEFINE_MUTEX(acpi_link_lock);
> +static int sci_irq = -1, sci_penalty;
>
> /* --------------------------------------------------------------------------
> PCI Link Device Management
> @@ -496,25 +497,13 @@ static int acpi_irq_get_penalty(int irq)
> {
> int penalty = 0;
>
> - /*
> - * Penalize IRQ used by ACPI SCI. If ACPI SCI pin attributes conflict
> - * with PCI IRQ attributes, mark ACPI SCI as ISA_ALWAYS so it won't be
> - * use for PCI IRQs.
> - */
> - if (irq == acpi_gbl_FADT.sci_interrupt) {
> - u32 type = irq_get_trigger_type(irq) & IRQ_TYPE_SENSE_MASK;
> -
> - if (type != IRQ_TYPE_LEVEL_LOW)
> - penalty += PIRQ_PENALTY_ISA_ALWAYS;
> - else
> - penalty += PIRQ_PENALTY_PCI_USING;
> - }
> + if (irq == sci_irq)
> + penalty += sci_penalty;
>
> if (irq < ACPI_MAX_ISA_IRQS)
> return penalty + acpi_isa_irq_penalty[irq];
>
> - penalty += acpi_irq_pci_sharing_penalty(irq);
> - return penalty;
> + return penalty + acpi_irq_pci_sharing_penalty(irq);
> }
>
> int __init acpi_irq_penalty_init(void)
> @@ -881,6 +870,17 @@ bool acpi_isa_irq_available(int irq)
> acpi_irq_get_penalty(irq) < PIRQ_PENALTY_ISA_ALWAYS);
> }
>
> +void acpi_penalize_sci_irq(int irq, int trigger, int polarity)
> +{
> + sci_irq = irq;
> +
> + if (trigger == ACPI_MADT_TRIGGER_LEVEL &&
> + polarity == ACPI_MADT_POLARITY_ACTIVE_LOW)
> + sci_penalty = PIRQ_PENALTY_PCI_USING;
> + else
> + sci_penalty = PIRQ_PENALTY_ISA_ALWAYS;
> +}
> +
> /*
> * Over-ride default table to reserve additional IRQs for use by ISA
> * e.g. acpi_irq_isa=5
> diff --git a/include/linux/acpi.h b/include/linux/acpi.h
> index c5eaf2f..67d1d3e 100644
> --- a/include/linux/acpi.h
> +++ b/include/linux/acpi.h
> @@ -318,6 +318,7 @@ struct pci_dev;
> int acpi_pci_irq_enable (struct pci_dev *dev);
> void acpi_penalize_isa_irq(int irq, int active);
> bool acpi_isa_irq_available(int irq);
> +void acpi_penalize_sci_irq(int irq, int trigger, int polarity);
> void acpi_pci_irq_disable (struct pci_dev *dev);
>
> extern int ec_read(u8 addr, u8 *val);
This series fixes one or more network adapters not working in Linux
32-bit x86 guest running inside VirtualBox if I have 4 network
adapters enabled. The following message no longer appears in the
kernel log:
ACPI: No IRQ available for PCI Interrupt Link [LNKD]. Try pci=noacpi or acpi=off
Tested-by: Jonathan Liu <net147@xxxxxxxxx>
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
