The ULPI phy on qcom platforms needs to be initialized and
powered on after a USB reset and before we toggle the run/stop
bit. Otherwise, the phy locks up and doesn't work properly.
Therefore, add a flag to skip any phy power management in the
core layer, leaving it up to the glue driver to manage.
Acked-by: Peter Chen <peter.chen@xxxxxxx>
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx>
---
drivers/usb/chipidea/core.c | 6 ++++++
include/linux/usb/chipidea.h | 1 +
2 files changed, 7 insertions(+)
diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
index 01390e02ee53..532085a096d9 100644
--- a/drivers/usb/chipidea/core.c
+++ b/drivers/usb/chipidea/core.c
@@ -361,6 +361,9 @@ static int _ci_usb_phy_init(struct ci_hdrc *ci)
*/
static void ci_usb_phy_exit(struct ci_hdrc *ci)
{
+ if (ci->platdata->flags & CI_HDRC_OVERRIDE_PHY_CONTROL)
+ return;
+
if (ci->phy) {
phy_power_off(ci->phy);
phy_exit(ci->phy);
@@ -379,6 +382,9 @@ static int ci_usb_phy_init(struct ci_hdrc *ci)
{
int ret;
+ if (ci->platdata->flags & CI_HDRC_OVERRIDE_PHY_CONTROL)
+ return 0;
+
switch (ci->platdata->phy_mode) {
case USBPHY_INTERFACE_MODE_UTMI:
case USBPHY_INTERFACE_MODE_UTMIW:
diff --git a/include/linux/usb/chipidea.h b/include/linux/usb/chipidea.h
index f9be467d6695..d07b162073f7 100644
--- a/include/linux/usb/chipidea.h
+++ b/include/linux/usb/chipidea.h
@@ -57,6 +57,7 @@ struct ci_hdrc_platform_data {
#define CI_HDRC_OVERRIDE_AHB_BURST BIT(9)
#define CI_HDRC_OVERRIDE_TX_BURST BIT(10)
#define CI_HDRC_OVERRIDE_RX_BURST BIT(11)
+#define CI_HDRC_OVERRIDE_PHY_CONTROL BIT(12) /* Glue layer manages phy */
enum usb_dr_mode dr_mode;
#define CI_HDRC_CONTROLLER_RESET_EVENT 0
#define CI_HDRC_CONTROLLER_STOPPED_EVENT 1
--
2.10.0.297.gf6727b0
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
