Hi Stephen,
On 9/7/2016 9:44 PM, Stephen Boyd wrote:
On 08/30, Ritesh Harjani wrote:
On 8/26/2016 3:57 AM, Stephen Boyd wrote:
On 08/24, Ritesh Harjani wrote:
This adds support for sdhc-msm controllers to get supported
clk-rates from DT. sdhci-msm would need it's own set_clock
ops to be implemented. For this, supported clk-rates needs
to be populated in sdhci_msm_pltfm_data.
Signed-off-by: Ritesh Harjani <riteshh@xxxxxxxxxxxxxx>
---
Please include the DT binding review list in binding updates.
Sure, will do it.
.../devicetree/bindings/mmc/sdhci-msm.txt | 1 +
drivers/mmc/host/sdhci-msm.c | 60 ++++++++++++++++++++++
2 files changed, 61 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
index 485483a..6a83b38 100644
--- a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
+++ b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt
@@ -17,6 +17,7 @@ Required properties:
"iface" - Main peripheral bus clock (PCLK/HCLK - AHB Bus clock) (required)
"core" - SDC MMC clock (MCLK) (required)
"bus" - SDCC bus voter clock (optional)
+- clk-rates: Array of supported GCC clock frequencies for sdhc, Units - Hz.
Why not use OPPv2 binding for this? We already have a way to
express frequencies for devices with that binding, and we'll need
to attach voltages to those frequencies at some point in the
future if we want to handle DVFS on these devices.
OPPv2 may not work out in this case. This was also discussed at [1].
These clk-rates are not as per voltage points(or any OPP) but as per
bus speed mode request from higher layer.
That post you link to had a response from Andy that echoed the
same sentiment and then no reply.
Are they a set of frequencies the device can operate at? Yes. Do
they have associated voltages that aren't expressed in this
patch? Yes.
Perhaps I've missed something though and the index of the array
of rates corresponds to some bus speed mode? That isn't clearly
expressed in the binding. Do the frequencies come from some spec
for those bus speed modes? Either way, I'd like to understand why
we need to put frequency tables into DT (hint: the commit text
should explain that).
As discussed offline, I will get back on this.
Regards
Ritesh
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
