On Fri, Aug 05, 2016 at 02:46:00PM -0700, Stephen Boyd wrote:
> Quoting Peter Chen (2016-07-08 02:25:35)
> > On Thu, Jul 07, 2016 at 03:20:57PM -0700, Stephen Boyd wrote:
> > > The ULPI phy on qcom platforms needs to be initialized and
> > > powered on after a USB reset and before we toggle the run/stop
> > > bit. Otherwise, the phy locks up and doesn't work properly.
> > > Therefore, add a flag to skip any phy power management in the
> > > core layer, leaving it up to the glue driver to manage.
> > >
> > > Cc: Peter Chen <peter.chen@xxxxxxx>
> > > Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
> > > Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx>
> > > ---
> > > drivers/usb/chipidea/core.c | 6 ++++++
> > > include/linux/usb/chipidea.h | 1 +
> > > 2 files changed, 7 insertions(+)
> > >
> > > diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
> > > index 01390e02ee53..532085a096d9 100644
> > > --- a/drivers/usb/chipidea/core.c
> > > +++ b/drivers/usb/chipidea/core.c
> > > @@ -361,6 +361,9 @@ static int _ci_usb_phy_init(struct ci_hdrc *ci)
> > > */
> > > static void ci_usb_phy_exit(struct ci_hdrc *ci)
> > > {
> > > + if (ci->platdata->flags & CI_HDRC_OVERRIDE_PHY_CONTROL)
> > > + return;
> > > +
> > > if (ci->phy) {
> > > phy_power_off(ci->phy);
> > > phy_exit(ci->phy);
> > > @@ -379,6 +382,9 @@ static int ci_usb_phy_init(struct ci_hdrc *ci)
> > > {
> > > int ret;
> > >
> > > + if (ci->platdata->flags & CI_HDRC_OVERRIDE_PHY_CONTROL)
> > > + return 0;
> > > +
> >
> > How you handle the code for PHY getting at probe?
> >
>
> Which probe? Glue layer probe? In my case I'm not using the phy until
> the RESET/STOPPED event so I just rely on the chipidea core to get the
> phy and then control the phy manually in the glue layer.
I have no idea about it after reading your patch 10/22.
--
Best Regards,
Peter Chen
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
