On Wed, Dec 04, 2024 at 06:52:49PM +0800, Ziyue Zhang wrote:
> Add vdda-pll-max-microamp for vdda-pll-supply. The value of this property
> is from the power grid guide. It is the maximum current the regulator can
> provide. The property will be parsed by PCIe PHY driver to set the current
> load.
>
> Signed-off-by: Ziyue Zhang <quic_ziyuzhan@xxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/qcs615-ride.dts | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/qcs615-ride.dts b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
> index 18f131ae9e07..6d93ef0d886b 100644
> --- a/arch/arm64/boot/dts/qcom/qcs615-ride.dts
> +++ b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
> @@ -215,6 +215,7 @@ &pcie {
> &pcie_phy {
> vdda-phy-supply = <&vreg_l5a>;
> vdda-pll-supply = <&vreg_l12a>;
> + vdda-pll-max-microamp = <165000>;
It seems from the driver patch (patch 2/3) that you will apply this
load-request at init and release it at exit, which I believe will hold
the regulator at HPM always.
If that's the case, why is vreg_l12a declared with
regulator-allow-set-load and support LPM on this board?
If the regulator needs to be in HPM on this board, remove
regulator-allow-set-load and the LPM mode from the regulator.
In fact, you (all of you) should remove all regulator-allow-set-load and
LPM modes from the DT until you know what that implies - and then
provide specific patches with clear description of the impact when you
add it back.
Regards,
Bjorn
>
> status = "okay";
> };
> --
> 2.34.1
>
