Add configurations in devicetree for PCIe0, board related gpios,
PMIC regulators, etc.
Signed-off-by: Ziyue Zhang <quic_ziyuzhan@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 42 +++++++++++++++++++++++
1 file changed, 42 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
index 85b84778e85a..fe3200914f79 100644
--- a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
@@ -196,6 +196,23 @@ vreg_l9c: ldo9 {
};
};
+&pcie0 {
+ perst-gpios = <&tlmm 2 GPIO_ACTIVE_LOW>;
+ wake-gpios = <&tlmm 0 GPIO_ACTIVE_HIGH>;
+
+ pinctrl-0 = <&pcie0_default_state>;
+ pinctrl-names = "default";
+
+ status = "okay";
+};
+
+&pcie0_phy {
+ vdda-phy-supply = <&vreg_l6a>;
+ vdda-pll-supply = <&vreg_l5a>;
+
+ status = "okay";
+};
+
&qupv3_id_0 {
status = "okay";
};
@@ -215,6 +232,31 @@ &remoteproc_gpdsp {
status = "okay";
};
+&tlmm {
+ pcie0_default_state: pcie0-default-state {
+ wake-pins {
+ pins = "gpio0";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ clkreq-pins {
+ pins = "gpio1";
+ function = "pcie0_clkreq";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ perst-pins {
+ pins = "gpio2";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+ };
+};
+
&uart7 {
status = "okay";
};
--
2.34.1
