On Thu, Dec 05, 2024 at 10:36:11PM +0530, Jyothi Kumar Seerapu wrote: > The DMA TRE(Transfer ring element) buffer contains the DMA > buffer address. Accessing data from this address can cause > significant delays in SPI transfers, which can be mitigated to > some extent by utilizing immediate DMA support. > > QCOM GPI DMA hardware supports an immediate DMA feature for data > up to 8 bytes, storing the data directly in the DMA TRE buffer > instead of the DMA buffer address. This enhancement enables faster > SPI data transfers. > > This optimization reduces the average transfer time from 25 us to > 16 us for a single SPI transfer of 8 bytes length, with a clock > frequency of 50 MHz. > > Signed-off-by: Jyothi Kumar Seerapu <quic_jseerapu@xxxxxxxxxxx> > --- > > v3 -> v4: > - Instead using extra variable(immediate_dma) for Immediate dma > condition check, made it to inlined. > - Removed the extra brackets around Immediate dma condition check. > > Link to v3: > https://lore.kernel.org/lkml/20241204122059.24239-1-quic_jseerapu@xxxxxxxxxxx/ > > v2 -> v3: > - When to enable Immediate DMA support, control is moved to GPI driver > from SPI driver. > - Optimizations are done in GPI driver related to immediate dma changes. > - Removed the immediate dma supported changes in qcom-gpi-dma.h file > and handled in GPI driver. > > Link to v2: > https://lore.kernel.org/all/20241128133351.24593-2-quic_jseerapu@xxxxxxxxxxx/ > https://lore.kernel.org/all/20241128133351.24593-3-quic_jseerapu@xxxxxxxxxxx/ > > v1 -> v2: > - Separated the patches to dmaengine and spi subsystems > - Removed the changes which are not required for this feature from > qcom-gpi-dma.h file. > - Removed the type conversions used in gpi_create_spi_tre. > > Link to v1: > https://lore.kernel.org/lkml/20241121115201.2191-2-quic_jseerapu@xxxxxxxxxxx/ > > drivers/dma/qcom/gpi.c | 31 ++++++++++++++++++++++++++----- > 1 file changed, 26 insertions(+), 5 deletions(-) > > diff --git a/drivers/dma/qcom/gpi.c b/drivers/dma/qcom/gpi.c > index 52a7c8f2498f..9d4fc760bbe6 100644 > --- a/drivers/dma/qcom/gpi.c > +++ b/drivers/dma/qcom/gpi.c > @@ -27,6 +27,7 @@ > #define TRE_FLAGS_IEOT BIT(9) > #define TRE_FLAGS_BEI BIT(10) > #define TRE_FLAGS_LINK BIT(11) > +#define TRE_FLAGS_IMMEDIATE_DMA BIT(16) > #define TRE_FLAGS_TYPE GENMASK(23, 16) > > /* SPI CONFIG0 WD0 */ > @@ -64,6 +65,7 @@ > > /* DMA TRE */ > #define TRE_DMA_LEN GENMASK(23, 0) > +#define TRE_DMA_IMMEDIATE_LEN GENMASK(3, 0) > > /* Register offsets from gpi-top */ > #define GPII_n_CH_k_CNTXT_0_OFFS(n, k) (0x20000 + (0x4000 * (n)) + (0x80 * (k))) > @@ -1711,6 +1713,7 @@ static int gpi_create_spi_tre(struct gchan *chan, struct gpi_desc *desc, > dma_addr_t address; > struct gpi_tre *tre; > unsigned int i; > + int len; > > /* first create config tre if applicable */ > if (direction == DMA_MEM_TO_DEV && spi->set_config) { > @@ -1763,14 +1766,32 @@ static int gpi_create_spi_tre(struct gchan *chan, struct gpi_desc *desc, > tre_idx++; > > address = sg_dma_address(sgl); > - tre->dword[0] = lower_32_bits(address); > - tre->dword[1] = upper_32_bits(address); > + len = sg_dma_len(sgl); > > - tre->dword[2] = u32_encode_bits(sg_dma_len(sgl), TRE_DMA_LEN); > + /* Support Immediate dma for write transfers for data length up to 8 bytes */ > + if (direction == DMA_MEM_TO_DEV && len <= 2 * sizeof(tre->dword[0])) { > + /* > + * For Immediate dma, data length may not always be length of 8 bytes, > + * it can be length less than 8, hence initialize both dword's with 0 > + */ > + tre->dword[0] = 0; > + tre->dword[1] = 0; > + memcpy(&tre->dword[0], sg_virt(sgl), len); > + > + tre->dword[2] = u32_encode_bits(len, TRE_DMA_IMMEDIATE_LEN); > + } else { > + tre->dword[0] = lower_32_bits(address); > + tre->dword[1] = upper_32_bits(address); > + > + tre->dword[2] = u32_encode_bits(len, TRE_DMA_LEN); > + } > > tre->dword[3] = u32_encode_bits(TRE_TYPE_DMA, TRE_FLAGS_TYPE); > - if (direction == DMA_MEM_TO_DEV) > - tre->dword[3] |= u32_encode_bits(1, TRE_FLAGS_IEOT); > + tre->dword[3] |= u32_encode_bits(direction == DMA_MEM_TO_DEV && > + len <= 2 * sizeof(tre->dword[0]), > + TRE_FLAGS_IMMEDIATE_DMA); Don't repeat the condition, put it inside if. > + tre->dword[3] |= u32_encode_bits(direction == DMA_MEM_TO_DEV, > + TRE_FLAGS_IEOT); > > for (i = 0; i < tre_idx; i++) > dev_dbg(dev, "TRE:%d %x:%x:%x:%x\n", i, desc->tre[i].dword[0], > -- > 2.17.1 > -- With best wishes Dmitry
