Add descriptions of PMD8028 PMIC used on SM8750 platforms. Signed-off-by: Jishnu Prakash <quic_jprakash@xxxxxxxxxxx> Signed-off-by: Melody Olvera <quic_molvera@xxxxxxxxxxx> --- arch/arm64/boot/dts/qcom/pmd8028.dtsi | 62 +++++++++++++++++++++++++++++++++++ 1 file changed, 62 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/pmd8028.dtsi b/arch/arm64/boot/dts/qcom/pmd8028.dtsi new file mode 100644 index 0000000000000000000000000000000000000000..a00913e28a4ca94d04d8a195ae8a868e9dd2fea4 --- /dev/null +++ b/arch/arm64/boot/dts/qcom/pmd8028.dtsi @@ -0,0 +1,62 @@ +// SPDX-License-Identifier: BSD-3-Clause +/* + * Copyright (c) 2024 Qualcomm Innovation Center, Inc. All rights reserved. + */ + +#include <dt-bindings/interrupt-controller/irq.h> +#include <dt-bindings/spmi/spmi.h> + +/ { + thermal-zones { + pmd8028-thermal { + polling-delay-passive = <100>; + thermal-sensors = <&pmd8028_temp_alarm>; + + trips { + pmd8028_trip0: trip0 { + temperature = <95000>; + hysteresis = <0>; + type = "passive"; + }; + + pmd8028_trip1: trip1 { + temperature = <115000>; + hysteresis = <0>; + type = "hot"; + }; + + pmd8028_trip2: trip2 { + temperature = <145000>; + hysteresis = <0>; + type = "critical"; + }; + }; + }; + }; +}; + +&spmi_bus { + pmd8028: pmic@4 { + compatible = "qcom,pmd8028", "qcom,spmi-pmic"; + reg = <0x4 SPMI_USID>; + #address-cells = <1>; + #size-cells = <0>; + + pmd8028_temp_alarm: temp-alarm@a00 { + compatible = "qcom,spmi-temp-alarm"; + reg = <0xa00>; + interrupts = <0x4 0xa 0x0 IRQ_TYPE_EDGE_BOTH>; + #thermal-sensor-cells = <0>; + }; + + pmd8028_gpios: gpio@8800 { + compatible = "qcom,pmd8028-gpio", "qcom,spmi-gpio"; + reg = <0x8800>; + gpio-controller; + gpio-ranges = <&pmd8028_gpios 0 0 4>; + #gpio-cells = <2>; + interrupt-controller; + #interrupt-cells = <2>; + }; + }; +}; -- 2.46.1