Add wifi node and this wifi module is connected to PCIe port.
The following is qca6390 probe message:
ath11k_pci 0000:01:00.0: Adding to iommu group 12
ath11k_pci 0000:01:00.0: BAR 0 [mem 0x60400000-0x604fffff 64bit]: assigned
ath11k_pci 0000:01:00.0: enabling device (0000 -> 0002)
ath11k_pci 0000:01:00.0: MSI vectors: 32
ath11k_pci 0000:01:00.0: qca6390 hw2.0
ath11k_pci 0000:01:00.0: chip_id 0x0 chip_family 0xb board_id 0xff soc_id 0xffffffff
ath11k_pci 0000:01:00.0: fw_version 0x10121492 fw_build_timestamp 2021-11-04 11:23 fw_build_id
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
Signed-off-by: Jianhua Lu <lujianhua000@xxxxxxxxx>
---
changes in v4:
1. pick up Dmitry Baryshkov's Reviewed-by
changes in v3:
1. fix commit message typo (pice -> PCIe).
changes in v2:
1. add qcom,ath11k-calibration-variant property.
.../dts/qcom/sm8250-xiaomi-elish-common.dtsi | 19 +++++++++++++++++++
1 file changed, 19 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sm8250-xiaomi-elish-common.dtsi b/arch/arm64/boot/dts/qcom/sm8250-xiaomi-elish-common.dtsi
index ebea283f56ea..7a55e271c3ac 100644
--- a/arch/arm64/boot/dts/qcom/sm8250-xiaomi-elish-common.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8250-xiaomi-elish-common.dtsi
@@ -680,6 +680,25 @@ &pcie0_phy {
status = "okay";
};
+&pcieport0 {
+ wifi@0 {
+ compatible = "pci17cb,1101";
+ reg = <0x10000 0x0 0x0 0x0 0x0>;
+
+ vddrfacmn-supply = <&vreg_pmu_rfa_cmn>;
+ vddaon-supply = <&vreg_pmu_aon_0p59>;
+ vddwlcx-supply = <&vreg_pmu_wlcx_0p8>;
+ vddwlmx-supply = <&vreg_pmu_wlmx_0p85>;
+ vddrfa0p8-supply = <&vreg_pmu_rfa_0p8>;
+ vddrfa1p2-supply = <&vreg_pmu_rfa_1p2>;
+ vddrfa1p7-supply = <&vreg_pmu_rfa_1p7>;
+ vddpcie0p9-supply = <&vreg_pmu_pcie_0p9>;
+ vddpcie1p8-supply = <&vreg_pmu_pcie_1p8>;
+
+ qcom,ath11k-calibration-variant = "Xiaomi_Pad_5Pro";
+ };
+};
+
&pm8150_gpios {
vol_up_n: vol-up-n-state {
pins = "gpio6";
--
2.47.0
