On Thu, Nov 28, 2024 at 07:03:51PM +0530, Jyothi Kumar Seerapu wrote:
> The DMA TRE(Transfer ring element) buffer contains the DMA
> buffer address. Accessing data from this address can cause
> significant delays in SPI transfers, which can be mitigated to
> some extent by utilizing immediate DMA support.
>
> QCOM GPI DMA hardware supports an immediate DMA feature for data
> up to 8 bytes, storing the data directly in the DMA TRE buffer
> instead of the DMA buffer address. This enhancement enables faster
> SPI data transfers.
>
> This optimization reduces the average transfer time from 25 us to
> 16 us for a single SPI transfer of 8 bytes length, with a clock
> frequency of 50 MHz.
>
> Signed-off-by: Jyothi Kumar Seerapu <quic_jseerapu@xxxxxxxxxxx>
> ---
>
> v1 -> v2:
> - Moved the spi changes as patch2.
>
> drivers/spi/spi-geni-qcom.c | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c
> index 768d7482102a..53c8f6b7f3c5 100644
> --- a/drivers/spi/spi-geni-qcom.c
> +++ b/drivers/spi/spi-geni-qcom.c
> @@ -472,11 +472,18 @@ static int setup_gsi_xfer(struct spi_transfer *xfer, struct spi_geni_master *mas
> mas->cur_speed_hz = xfer->speed_hz;
> }
>
> + /*
> + * Set QCOM_GPI_IMMEDIATE_DMA flag if transfer length up to 8 bytes.
> + */
> if (xfer->tx_buf && xfer->rx_buf) {
> peripheral.cmd = SPI_DUPLEX;
> + if (xfer->len <= QCOM_GPI_IMMEDIATE_DMA_LEN)
> + peripheral.flags |= QCOM_GPI_IMMEDIATE_DMA;
> } else if (xfer->tx_buf) {
> peripheral.cmd = SPI_TX;
> peripheral.rx_len = 0;
> + if (xfer->len <= QCOM_GPI_IMMEDIATE_DMA_LEN)
> + peripheral.flags |= QCOM_GPI_IMMEDIATE_DMA;
NAK. Please finish discussions in the previous iteration before posting
new revision. Sending your responses together with sending next
iteration is a bad practice and is frowned upon (unless one agrees to
all the comments).
There was an open question here and your answer doesn't sound convincing
enough. Please continue discussion in v1.
> } else if (xfer->rx_buf) {
> peripheral.cmd = SPI_RX;
> if (!(mas->cur_bits_per_word % MIN_WORD_LEN)) {
> --
> 2.17.1
>
--
With best wishes
Dmitry
