Avoid writing unavailable register in BAM-Lite mode.
BAM_DESC_CNT_TRSHLD register is unavailable in BAM-Lite
mode. Its only available in BAM-NDP mode. So avoid writing
this register for clients who is using BAM-Lite mode.
Signed-off-by: Md Sadre Alam <quic_mdalam@xxxxxxxxxxx>
---
drivers/dma/qcom/bam_dma.c | 22 ++++++++++++++--------
1 file changed, 14 insertions(+), 8 deletions(-)
diff --git a/drivers/dma/qcom/bam_dma.c b/drivers/dma/qcom/bam_dma.c
index d43a881e43b9..13a08c03746b 100644
--- a/drivers/dma/qcom/bam_dma.c
+++ b/drivers/dma/qcom/bam_dma.c
@@ -59,6 +59,9 @@ struct bam_desc_hw {
#define DESC_FLAG_NWD BIT(12)
#define DESC_FLAG_CMD BIT(11)
+#define BAM_LITE 0x13
+#define BAM_NDP 0x20
+
struct bam_async_desc {
struct virt_dma_desc vd;
@@ -398,6 +401,7 @@ struct bam_device {
/* dma start transaction tasklet */
struct tasklet_struct task;
+ u32 bam_revision;
};
/**
@@ -441,8 +445,9 @@ static void bam_reset(struct bam_device *bdev)
writel_relaxed(val, bam_addr(bdev, 0, BAM_CTRL));
/* set descriptor threshold, start with 4 bytes */
- writel_relaxed(DEFAULT_CNT_THRSHLD,
- bam_addr(bdev, 0, BAM_DESC_CNT_TRSHLD));
+ if (bdev->bam_revision >= BAM_LITE && bdev->bam_revision < BAM_NDP)
+ writel_relaxed(DEFAULT_CNT_THRSHLD,
+ bam_addr(bdev, 0, BAM_DESC_CNT_TRSHLD));
/* Enable default set of h/w workarounds, ie all except BAM_FULL_PIPE */
writel_relaxed(BAM_CNFG_BITS_DEFAULT, bam_addr(bdev, 0, BAM_CNFG_BITS));
@@ -1000,9 +1005,9 @@ static void bam_apply_new_config(struct bam_chan *bchan,
maxburst = bchan->slave.src_maxburst;
else
maxburst = bchan->slave.dst_maxburst;
-
- writel_relaxed(maxburst,
- bam_addr(bdev, 0, BAM_DESC_CNT_TRSHLD));
+ if (bdev->bam_revision >= BAM_LITE && bdev->bam_revision < BAM_NDP)
+ writel_relaxed(maxburst,
+ bam_addr(bdev, 0, BAM_DESC_CNT_TRSHLD));
}
bchan->reconfigure = 0;
@@ -1192,10 +1197,11 @@ static int bam_init(struct bam_device *bdev)
u32 val;
/* read revision and configuration information */
- if (!bdev->num_ees) {
- val = readl_relaxed(bam_addr(bdev, 0, BAM_REVISION));
+ val = readl_relaxed(bam_addr(bdev, 0, BAM_REVISION));
+ if (!bdev->num_ees)
bdev->num_ees = (val >> NUM_EES_SHIFT) & NUM_EES_MASK;
- }
+
+ bdev->bam_revision = val & 0xff;
/* check that configured EE is within range */
if (bdev->ee >= bdev->num_ees)
--
2.34.1
