On Sun 26 Jun 00:28 PDT 2016, Stephen Boyd wrote: > We need to pick the correct phy at runtime based on how the SoC > has been wired onto the board. If the secondary phy is used, take > it out of reset and mux over to it by writing into the TCSR > register. Make sure to do this on reset too, because this > register is reset to the default value (primary phy) after the > RESET bit is set in USBCMD. > > Cc: Peter Chen <peter.chen@xxxxxxx> > Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> > Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx> > --- > drivers/usb/chipidea/ci_hdrc_msm.c | 78 +++++++++++++++++++++++++++++++++++--- > 1 file changed, 73 insertions(+), 5 deletions(-) > > diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c b/drivers/usb/chipidea/ci_hdrc_msm.c [..] > > +static int ci_hdrc_msm_mux_phy(struct ci_hdrc_msm *ci, > + struct platform_device *pdev) > +{ > + struct regmap *regmap; > + struct device_node *syscon; > + struct device *dev = &pdev->dev; > + u32 off, val; > + int ret; > + > + syscon = of_parse_phandle(dev->of_node, "phy-select", 0); > + if (!syscon) > + return 0; > + > + regmap = syscon_node_to_regmap(syscon); > + if (IS_ERR(regmap)) > + return PTR_ERR(regmap); > + > + ret = of_property_read_u32_index(dev->of_node, "phy-select", 1, &off); > + if (ret < 0) { > + dev_err(dev, "no offset in syscon\n"); > + return -EINVAL; > + } > + > + ret = of_property_read_u32_index(dev->of_node, "phy-select", 2, &val); > + if (ret < 0) { > + dev_err(dev, "no value in syscon\n"); > + return -EINVAL; > + } > + > + ret = regmap_write(regmap, off, val); I recently found out (thanks to a comment from Srinivas) that you can drop the last two error checks by using of_parse_phandle_with_fixed_args() as in: struct of_phandle_args args; ret = of_parse_phandle_with_fixed_args(dev->of_node, "phy-select", 2, 0, &args); if (ret < 0) ... regmap = syscon_node_to_regmap(args.np); of_node_put(args.np); if (IS_ERR(regmap)) ... ret = regmap_write(regmap, args.args[0], args.args[1]); > + if (ret) > + return ret; > + > + ci->secondary_phy = !!val; > + if (ci->secondary_phy) { > + val = readl_relaxed(ci->base + HS_PHY_SEC_CTRL); > + val |= HS_PHY_DIG_CLAMP_N; > + writel_relaxed(val, ci->base + HS_PHY_SEC_CTRL); > + } > + > + return 0; > +} > + > static int ci_hdrc_msm_probe(struct platform_device *pdev) > { > struct ci_hdrc_msm *ci; > struct platform_device *plat_ci; > struct clk *clk; > struct reset_control *reset; > + struct resource *res; > + void __iomem *base; Doesn't look like you need "base". > + resource_size_t size; > int ret; > > dev_dbg(&pdev->dev, "ci_hdrc_msm_probe\n"); > @@ -76,6 +132,15 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev) > if (IS_ERR(clk)) > return PTR_ERR(clk); > > + res = platform_get_resource(pdev, IORESOURCE_MEM, 0); > + if (!res) > + return -ENODEV; > + > + size = resource_size(res); > + ci->base = base = devm_ioremap(&pdev->dev, res->start, size); > + if (!base) > + return -ENOMEM; Replace these two snippets with: res = platform_get_resource(pdev, IORESOURCE_MEM, 0); ci->base = devm_ioremap_resource(&pdev->dev, res); if (IS_ERR(ci->base)) return PTR_ERR(ci->base); > + > reset_control_assert(reset); > usleep_range(10000, 12000); > reset_control_deassert(reset); Regards, Bjorn -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html