Re: [PATCH v3 1/2] arm64: dts: qcom: sa8775p: add DisplayPort device nodes

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Nov 14, 2024 at 03:24:59PM +0530, Soutrik Mukhopadhyay wrote:
> Add device tree nodes for the DPTX0 and DPTX1 controllers
> with their corresponding PHYs found on Qualcomm SA8775P SoC.
> 
> Signed-off-by: Soutrik Mukhopadhyay <quic_mukhopad@xxxxxxxxxxx>

This most likely wasn't validated against DT schema. Please don't send
unvalidated DT patches.

> ---
>  arch/arm64/boot/dts/qcom/sa8775p.dtsi | 216 +++++++++++++++++++++++++-
>  1 file changed, 215 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sa8775p.dtsi b/arch/arm64/boot/dts/qcom/sa8775p.dtsi
> index f7a9d1684a79..b272feae8da1 100644
> --- a/arch/arm64/boot/dts/qcom/sa8775p.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sa8775p.dtsi
> @@ -3343,6 +3343,25 @@
>  				interrupt-parent = <&mdss0>;
>  				interrupts = <0>;
>  
> +				ports {
> +					#address-cells = <1>;
> +					#size-cells = <0>;
> +
> +					port@0 {
> +						reg = <0>;
> +						dpu_intf0_out: endpoint {
> +							remote-endpoint = <&mdss0_dp0_in>;
> +						};
> +					};
> +
> +					port@1 {
> +						reg = <1>;
> +						dpu_intf4_out: endpoint {
> +							remote-endpoint = <&mdss0_dp1_in>;
> +						};
> +					};
> +				};
> +
>  				mdss0_mdp_opp_table: opp-table {
>  					compatible = "operating-points-v2";
>  
> @@ -3367,6 +3386,200 @@
>  					};
>  				};
>  			};
> +
> +			mdss0_dp0_phy: phy@aec2a00 {
> +				compatible = "qcom,sa8775p-edp-phy";
> +
> +				reg = <0x0 0xaec2a00 0x0 0x200>,
> +				      <0x0 0xaec2200 0x0 0xd0>,
> +				      <0x0 0xaec2600 0x0 0xd0>,
> +				      <0x0 0xaec2000 0x0 0x1c8>;
> +
> +				clocks =<&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_AUX_CLK>,
> +					<&dispcc0 MDSS_DISP_CC_MDSS_AHB_CLK>;
> +				clock-names = "aux",
> +					      "cfg_ahb";
> +
> +				#clock-cells = <1>;
> +				#phy-cells = <0>;
> +
> +				status = "disabled";
> +			};
> +
> +			mdss0_dp1_phy: phy@aec5a00 {
> +				compatible = "qcom,sa8775p-edp-phy";
> +
> +				reg = <0x0 0xaec5a00 0x0 0x200>,
> +				      <0x0 0xaec5200 0x0 0xd0>,
> +				      <0x0 0xaec5600 0x0 0xd0>,
> +				      <0x0 0xaec5000 0x0 0x1c8>;
> +
> +				clocks =<&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_AUX_CLK>,
> +					<&dispcc0 MDSS_DISP_CC_MDSS_AHB_CLK>;
> +				clock-names = "aux",
> +					      "cfg_ahb";
> +
> +				#clock-cells = <1>;
> +				#phy-cells = <0>;
> +
> +				status = "disabled";
> +			};
> +
> +			mdss0_dp0: displayport-controller@af54000 {
> +				compatible = "qcom,sa8775p-dp";
> +
> +				reg = <0x0 0xaf54000 0x0 0x104>,
> +				      <0x0 0xaf54200 0x0 0x0c0>,
> +				      <0x0 0xaf55000 0x0 0x770>,
> +				      <0x0 0xaf56000 0x0 0x09c>;

No p1 region?

> +
> +				interrupt-parent = <&mdss0>;
> +				interrupts = <12>;
> +
> +				clocks = <&dispcc0 MDSS_DISP_CC_MDSS_AHB_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_AUX_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_LINK_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_LINK_INTF_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_PIXEL0_CLK>;
> +				clock-names = "core_iface",
> +					      "core_aux",
> +					      "ctrl_link",
> +					      "ctrl_link_iface",
> +					      "stream_pixel";
> +				assigned-clocks = <&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_LINK_CLK_SRC>,
> +						  <&dispcc0 MDSS_DISP_CC_MDSS_DPTX0_PIXEL0_CLK_SRC>;
> +				assigned-clock-parents = <&mdss0_dp0_phy 0>, <&mdss0_dp0_phy 1>;
> +				phys = <&mdss0_dp0_phy>;
> +				phy-names = "dp";
> +
> +				operating-points-v2 = <&dp_opp_table>;
> +				power-domains = <&rpmhpd SA8775P_MMCX>;
> +
> +				#sound-dai-cells = <0>;
> +
> +				status = "disabled";
> +
> +				ports {
> +					#address-cells = <1>;
> +					#size-cells = <0>;
> +
> +					port@0 {
> +						reg = <0>;
> +
> +						mdss0_dp0_in: endpoint {
> +							remote-endpoint = <&dpu_intf0_out>;
> +						};
> +					};
> +
> +					port@1 {
> +						reg = <1>;
> +
> +						mdss0_dp0_out: endpoint { };
> +					};
> +				};
> +
> +				dp_opp_table: opp-table {
> +					compatible = "operating-points-v2";
> +
> +					opp-160000000 {
> +						opp-hz = /bits/ 64 <160000000>;
> +						required-opps = <&rpmhpd_opp_low_svs>;
> +					};
> +
> +					opp-270000000 {
> +						opp-hz = /bits/ 64 <270000000>;
> +						required-opps = <&rpmhpd_opp_svs>;
> +					};
> +
> +					opp-540000000 {
> +						opp-hz = /bits/ 64 <540000000>;
> +						required-opps = <&rpmhpd_opp_svs_l1>;
> +					};
> +
> +					opp-810000000 {
> +						opp-hz = /bits/ 64 <810000000>;
> +						required-opps = <&rpmhpd_opp_nom>;
> +					};
> +				};
> +			};
> +
> +			mdss0_dp1: displayport-controller@af5c000 {
> +				compatible = "qcom,sa8775p-dp";
> +
> +				reg = <0x0 0xaf5c000 0x0 0x104>,
> +				      <0x0 0xaf5c200 0x0 0x0c0>,
> +				      <0x0 0xaf5d000 0x0 0x770>,
> +				      <0x0 0xaf5e000 0x0 0x09c>;
> +
> +				interrupt-parent = <&mdss0>;
> +				interrupts = <13>;
> +
> +				clocks = <&dispcc0 MDSS_DISP_CC_MDSS_AHB_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_AUX_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_LINK_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_LINK_INTF_CLK>,
> +					 <&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_PIXEL0_CLK>;
> +				clock-names = "core_iface",
> +					      "core_aux",
> +					      "ctrl_link",
> +					      "ctrl_link_iface",
> +					      "stream_pixel";
> +				assigned-clocks = <&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_LINK_CLK_SRC>,
> +						  <&dispcc0 MDSS_DISP_CC_MDSS_DPTX1_PIXEL0_CLK_SRC>;
> +				assigned-clock-parents = <&mdss0_dp1_phy 0>, <&mdss0_dp1_phy 1>;
> +				phys = <&mdss0_dp1_phy>;
> +				phy-names = "dp";
> +
> +				operating-points-v2 = <&dp1_opp_table>;
> +				power-domains = <&rpmhpd SA8775P_MMCX>;
> +
> +				#sound-dai-cells = <0>;
> +
> +				status = "disabled";
> +
> +				ports {
> +					#address-cells = <1>;
> +					#size-cells = <0>;
> +
> +					port@0 {
> +						reg = <0>;
> +
> +						mdss0_dp1_in: endpoint {
> +							remote-endpoint = <&dpu_intf4_out>;
> +						};
> +					};
> +
> +					port@1 {
> +						reg = <1>;
> +
> +						mdss0_dp1_out: endpoint { };
> +					};
> +				};
> +
> +				dp1_opp_table: opp-table {
> +					compatible = "operating-points-v2";
> +
> +					opp-160000000 {
> +						opp-hz = /bits/ 64 <160000000>;
> +						required-opps = <&rpmhpd_opp_low_svs>;
> +					};
> +
> +					opp-270000000 {
> +						opp-hz = /bits/ 64 <270000000>;
> +						required-opps = <&rpmhpd_opp_svs>;
> +					};
> +
> +					opp-540000000 {
> +						opp-hz = /bits/ 64 <540000000>;
> +						required-opps = <&rpmhpd_opp_svs_l1>;
> +					};
> +
> +					opp-810000000 {
> +						opp-hz = /bits/ 64 <810000000>;
> +						required-opps = <&rpmhpd_opp_nom>;
> +					};
> +				};
> +			};
>  		};
>  
>  		dispcc0: clock-controller@af00000 {
> @@ -3376,7 +3589,8 @@
>  				 <&rpmhcc RPMH_CXO_CLK>,
>  				 <&rpmhcc RPMH_CXO_CLK_A>,
>  				 <&sleep_clk>,
> -				 <0>, <0>, <0>, <0>,
> +				 <&mdss0_dp0_phy 0>, <&mdss0_dp0_phy 1>,
> +				 <&mdss0_dp1_phy 0>, <&mdss0_dp1_phy 1>,
>  				 <0>, <0>, <0>, <0>;
>  			power-domains = <&rpmhpd SA8775P_MMCX>;
>  			#clock-cells = <1>;
> -- 
> 2.17.1
> 

-- 
With best wishes
Dmitry




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux