On 11-Nov-24 12:51, Manikanta Mylavarapu wrote:
>
>
> On 11/7/2024 8:17 PM, Konrad Dybcio wrote:
>> On 6.11.2024 11:25 AM, Manikanta Mylavarapu wrote:
>>>
>>>
>>> On 11/6/2024 2:42 PM, Konrad Dybcio wrote:
>>>>
>>>>
>>>> On 11/6/24 09:47, Manikanta Mylavarapu wrote:
>>>>>
>>>>>
>>>>> On 11/4/2024 7:21 PM, Konrad Dybcio wrote:
>>>>>> On 4.11.2024 1:44 PM, Manikanta Mylavarapu wrote:
>>>>>>> Add thermal zone nodes for sensors present in IPQ5424.
>>>>>>>
>>>>>>> Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@xxxxxxxxxxx>
>>>>>>> ---
>>>>>> [...]
>>>>>>
>>>>>>> +
>>>>>>> + cpu3-thermal {
>>>>>>> + polling-delay-passive = <0>;
>>>>>>> + polling-delay = <0>;
>>>>>>> + thermal-sensors = <&tsens 13>;
>>>>>>> +
>>>>>>> + trips {
>>>>>>> + cpu-critical {
>>>>>>> + temperature = <120000>;
>>>>>>> + hysteresis = <9000>;
>>>>>>> + type = "critical";
>>>>>>> + };
>>>>>>> +
>>>>>>> + cpu-passive {
>>>>>>> + temperature = <110000>;
>>>>>>> + hysteresis = <9000>;
>>>>>>> + type = "passive";
>>>>>>
>>>>>> You have a passive trip point without passive polling
>>>>>>
>>>>>
>>>>> Okay, will remove this.
>>>>
>>>> You most likely want to preserve it, while keeping a sensible
>>>> polling frequency, so that userspace will be aware of the current
>>>> CPU temperature. <100> sounds like a sensible value here.
>>>>
>>>> Konrad
>>>
>>> Temperature sensor's present in IPQ5424 supports interrupts.
>>
>> Correct.
>>
>>> Hence no need to configure polling frequency.
>>
>> No, that interrupt firing signifies crossing the temp threshold (meaning
>> no updates beyond that) or the tsens watchdog barking.
>>
>> Konrad
>
> An interrupt fires when the temperature crosses a threshold.
Which means you can't monitor the temperature at runtime
without polling..
Konrad
