From: Praveenkumar I <quic_ipkumar@xxxxxxxxxxx>
This patch adds thermal zone nodes for sensors present in
IPQ5332.
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
Signed-off-by: Praveenkumar I <quic_ipkumar@xxxxxxxxxxx>
Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@xxxxxxxxxxx>
---
Changes in V7:
- Remove polling-delay-passive/polling-delay because the default value is 0.
No need to configure explicitly.
arch/arm64/boot/dts/qcom/ipq5332.dtsi | 68 +++++++++++++++++++++++++++
1 file changed, 68 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/ipq5332.dtsi b/arch/arm64/boot/dts/qcom/ipq5332.dtsi
index 897b961d5879..26c5aefc17a0 100644
--- a/arch/arm64/boot/dts/qcom/ipq5332.dtsi
+++ b/arch/arm64/boot/dts/qcom/ipq5332.dtsi
@@ -554,4 +554,72 @@ timer {
<GIC_PPI 4 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
<GIC_PPI 1 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>;
};
+
+ thermal-zones {
+ rfa-0-thermal {
+ thermal-sensors = <&tsens 11>;
+
+ trips {
+ rfa-0-critical {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "critical";
+ };
+ };
+ };
+
+ rfa-1-thermal {
+ thermal-sensors = <&tsens 12>;
+
+ trips {
+ rfa-1-critical {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "critical";
+ };
+ };
+ };
+
+ misc-thermal {
+ thermal-sensors = <&tsens 13>;
+
+ trips {
+ misc-critical {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "critical";
+ };
+ };
+ };
+
+ cpu-top-thermal {
+ thermal-sensors = <&tsens 14>;
+
+ trips {
+ cpu-top-critical {
+ temperature = <115000>;
+ hysteresis = <1000>;
+ type = "critical";
+ };
+
+ cpu-passive {
+ temperature = <105000>;
+ hysteresis = <1000>;
+ type = "passive";
+ };
+ };
+ };
+
+ top-glue-thermal {
+ thermal-sensors = <&tsens 15>;
+
+ trips {
+ top-glue-critical {
+ temperature = <125000>;
+ hysteresis = <1000>;
+ type = "critical";
+ };
+ };
+ };
+ };
};
--
2.34.1
