The lucid 5lpe PLL enable check only checks for an impossible negative
return value and does not actually return as intended in case the PLL is
already enabled (e.g. has been left enabled by boot firmware).
Fixes: f4c7e27aa4b6 ("clk: qcom: clk-alpha-pll: Add support for Lucid 5LPE PLL")
Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
---
drivers/clk/qcom/clk-alpha-pll.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/clk/qcom/clk-alpha-pll.c b/drivers/clk/qcom/clk-alpha-pll.c
index 99d6962d25bb..bd1dbef04d9d 100644
--- a/drivers/clk/qcom/clk-alpha-pll.c
+++ b/drivers/clk/qcom/clk-alpha-pll.c
@@ -1903,9 +1903,8 @@ static int alpha_pll_lucid_5lpe_enable(struct clk_hw *hw)
}
/* Check if PLL is already enabled, return if enabled */
- ret = trion_pll_is_enabled(pll, pll->clkr.regmap);
- if (ret < 0)
- return ret;
+ if (trion_pll_is_enabled(pll, pll->clkr.regmap))
+ return 0;
ret = regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), PLL_RESET_N, PLL_RESET_N);
if (ret)
--
2.45.2
