From: Balamurugan S <quic_bselvara@xxxxxxxxxxx>
Add ath12k_hw_params for new ath12k AHB based WiFi device IPQ5332.
Some hardware parameters like hw_ops, wmi_init & hal_ops are same
between IPQ5332 and QCN9274, hence use these same parameters for
IPQ5332. Other parameters are specific to IPQ5332, and those are
initially set to 0 or NULL, and will be populated in subsequent
patches.
Tested-on: IPQ5332 hw1.0 AHB WLAN.WBE.1.3.1-00130-QCAHKSWPL_SILICONZ-1
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00210-QCAHKSWPL_SILICONZ-1
Signed-off-by: Balamurugan S <quic_bselvara@xxxxxxxxxxx>
Co-developed-by: P Praneesh <quic_ppranees@xxxxxxxxxxx>
Signed-off-by: P Praneesh <quic_ppranees@xxxxxxxxxxx>
Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag@xxxxxxxxxxx>
---
drivers/net/wireless/ath/ath12k/core.h | 3 +-
drivers/net/wireless/ath/ath12k/hw.c | 71 ++++++++++++++++++++++++++
drivers/net/wireless/ath/ath12k/qmi.h | 1 +
3 files changed, 74 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath12k/core.h b/drivers/net/wireless/ath/ath12k/core.h
index ebfc1e370acc..126c9fed1fad 100644
--- a/drivers/net/wireless/ath/ath12k/core.h
+++ b/drivers/net/wireless/ath/ath12k/core.h
@@ -128,7 +128,8 @@ struct ath12k_skb_rxcb {
enum ath12k_hw_rev {
ATH12K_HW_QCN9274_HW10,
ATH12K_HW_QCN9274_HW20,
- ATH12K_HW_WCN7850_HW20
+ ATH12K_HW_WCN7850_HW20,
+ ATH12K_HW_IPQ5332_HW10,
};
enum ath12k_firmware_mode {
diff --git a/drivers/net/wireless/ath/ath12k/hw.c b/drivers/net/wireless/ath/ath12k/hw.c
index ec1bda95e555..7ca6ec99fd6e 100644
--- a/drivers/net/wireless/ath/ath12k/hw.c
+++ b/drivers/net/wireless/ath/ath12k/hw.c
@@ -1085,6 +1085,77 @@ static const struct ath12k_hw_params ath12k_hw_params[] = {
.supports_aspm = false,
},
+ {
+ .name = "ipq5332 hw1.0",
+ .hw_rev = ATH12K_HW_IPQ5332_HW10,
+ .fw = {
+ .dir = "IPQ5332/hw1.0",
+ .board_size = 256 * 1024,
+ .cal_offset = 128 * 1024,
+ },
+ .max_radios = 1,
+ .single_pdev_only = false,
+ .qmi_service_ins_id = ATH12K_QMI_WLFW_SERVICE_INS_ID_V01_IPQ5332,
+ .internal_sleep_clock = false,
+
+ .hw_ops = &qcn9274_ops,
+ .regs = NULL,
+ .ring_mask = NULL,
+
+ .host_ce_config = NULL,
+ .ce_count = 0,
+ .target_ce_config = NULL,
+ .target_ce_count = 0,
+ .svc_to_ce_map = NULL,
+ .svc_to_ce_map_len = 0,
+
+ .hal_params = NULL,
+
+ .rxdma1_enable = false,
+ .num_rxdma_per_pdev = 1,
+ .num_rxdma_dst_ring = 0,
+ .rx_mac_buf_ring = false,
+ .vdev_start_delay = false,
+
+ .interface_modes = BIT(NL80211_IFTYPE_STATION) |
+ BIT(NL80211_IFTYPE_AP) |
+ BIT(NL80211_IFTYPE_MESH_POINT),
+ .supports_monitor = false,
+
+ .idle_ps = false,
+ .download_calib = true,
+ .supports_suspend = false,
+ .tcl_ring_retry = true,
+ .reoq_lut_support = false,
+ .supports_shadow_regs = false,
+
+ .num_tcl_banks = 48,
+ .max_tx_ring = 4,
+
+ .wmi_init = &ath12k_wmi_init_qcn9274,
+
+ .hal_ops = &hal_qcn9274_ops,
+
+ .qmi_cnss_feature_bitmap = BIT(CNSS_QDSS_CFG_MISS_V01),
+
+ .rfkill_pin = 0,
+ .rfkill_cfg = 0,
+ .rfkill_on_level = 0,
+
+ .rddm_size = 0,
+
+ .def_num_link = 0,
+ .max_mlo_peer = 256,
+
+ .otp_board_id_register = 0,
+
+ .supports_sta_ps = false,
+
+ .acpi_guid = NULL,
+ .supports_dynamic_smps_6ghz = false,
+ .iova_mask = 0,
+ .supports_aspm = false,
+ },
};
int ath12k_hw_init(struct ath12k_base *ab)
diff --git a/drivers/net/wireless/ath/ath12k/qmi.h b/drivers/net/wireless/ath/ath12k/qmi.h
index 0dfcbd8cb59b..6ce11060f1aa 100644
--- a/drivers/net/wireless/ath/ath12k/qmi.h
+++ b/drivers/net/wireless/ath/ath12k/qmi.h
@@ -21,6 +21,7 @@
#define ATH12K_QMI_WLFW_SERVICE_INS_ID_V01_WCN7850 0x1
#define ATH12K_QMI_WLFW_SERVICE_INS_ID_V01_QCN9274 0x07
+#define ATH12K_QMI_WLFW_SERVICE_INS_ID_V01_IPQ5332 0x2
#define ATH12K_QMI_WLANFW_MAX_TIMESTAMP_LEN_V01 32
#define ATH12K_QMI_RESP_LEN_MAX 8192
#define ATH12K_QMI_WLANFW_MAX_NUM_MEM_SEG_V01 52
--
2.34.1
