Re: [PATCH 2/3] arm64: dts: qcom: sm8250-xiaomi-elish: Add wifi node

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Oct 07, 2024 at 12:02:34AM +0300, Dmitry Baryshkov wrote:
> On Sun, Sep 29, 2024 at 07:29:07PM GMT, Jianhua Lu wrote:
> > Add wifi node and this wifi module is connected to pice port.
> 
> Could you please add ath11k probe messages to the log? We might need to
> add an additional node with the calibration variant.
> 
Hi, Dmitry. Do you mean that I should add ath11k probe message to the commit message?
The following is ath11k probe message:
[   10.285469] ath11k_pci 0000:01:00.0: Adding to iommu group 12
[   10.285637] ath11k_pci 0000:01:00.0: BAR 0 [mem 0x60400000-0x604fffff 64bit]: assigned
[   10.285699] ath11k_pci 0000:01:00.0: enabling device (0000 -> 0002)
[   10.286003] ath11k_pci 0000:01:00.0: MSI vectors: 32
[   10.286023] ath11k_pci 0000:01:00.0: qca6390 hw2.0
[   10.652407] ath11k_pci 0000:01:00.0: chip_id 0x0 chip_family 0xb board_id 0xff soc_id 0xffffffff
[   10.652429] ath11k_pci 0000:01:00.0: fw_version 0x10121492 fw_build_timestamp 2021-11-04 11:23 fw_build_id

I'm not sure if it's necessary to add calibration variant because wifi
works normally on this board without adding calibration variant.




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux